Where do you put the parking brake wire?
The “parking brake” wire from the radio would go on the center terminal of the switch and the wire coming up from the parking brake would go on either of the other terminals and then lastly a ground wire on the third terminal. This will give you your either or switching you want
How do you install a car navigation system?
Insert the tap wire into the large cap and hand tighten into the barrel. The conductor point pierces the tapped wire without compromising its conductive integrity. Slide the stripped end of the accessory wire through the small cap.
Can a navigation receiver be installed in the dash?
For the most part, installing an in-dash navigation receiver is quite similar to installing regular touchscreen stereos. But there are a couple of additional wrinkles: a GPS antenna and a reverse-direction sensor. This article will focus on these extra steps for the navigation receiver’s installation.
How to install navtool on a German vehicle?
When installing NavTool on German vehicles relay must be installed, please see below: Connect 85 of relay to ground, connect 86 of relay to reverse light, connect pin 30 of relay to accessory power, connect pin 87 of relay to Orange wire from NavTool Interface, you may also connect 87 of relay to accessory power for back up camera.
The “parking brake” wire from the radio would go on the center terminal of the switch and the wire coming up from the parking brake would go on either of the other terminals and then lastly a ground wire on the third terminal. This will give you your either or switching you want
Insert the tap wire into the large cap and hand tighten into the barrel. The conductor point pierces the tapped wire without compromising its conductive integrity. Slide the stripped end of the accessory wire through the small cap.
Where is the brake wire on a Xtron?
Brake Wire The brake wire is supposed to be connected to the handbrake, in general this will have a silver tag marked BRAKE, PARK or something similar. This allows you to only watch the DVD or TV when you pull the handbrake so you can only view this function when the vehicle is parked, this is for your own safety.
For the most part, installing an in-dash navigation receiver is quite similar to installing regular touchscreen stereos. But there are a couple of additional wrinkles: a GPS antenna and a reverse-direction sensor. This article will focus on these extra steps for the navigation receiver’s installation.