What do I need to replace tail light bulb?
Replacement bulbs with their part numbers are as follows: Brake # 2357, Rear Turn Signal # 1156NA or 1156A, Reverse # 921, Rear Side Marker Light # 168 and Parking Light # 2357. The only tool required to replace the bulbs is a standard Phillips head screwdriver.
How are tail light bulbs held in place?
The tail light assembly is still held in place by three metal pegs or “spikes” on the rear outer edge that act as friction fasteners inserted in to plastic grommets on the metal body. Gently pull the tail light housing straight off the rear of the vehicle. If you have trouble removing the housing, try gently wiggling it while pulling.
Where are the tail lights on a Kia Soul?
Turn over the tail light housing and locate the electrical connector. Press the release tab on the power plug and slide it straight out of its socket. Set the tail light assembly down on the cargo area carpet. The Parking Light bulb is located at the top of the housing.
Where is the rear turn signal light bulb?
The Rear Turn Signal light bulb socket is located just below the parking light bulb and closer to the center of the housing. Rotate the socket 1/4 turn counter clockwise and pull it straight out of the housing. Push the old bulb down in to the socket and rotate it 1/4 turn counter clockwise before pulling it straight out of the socket.
How can I replace my tail light bulb?
You can easily replace your own tail light bulbs with a few simple tools and the right bulb. Start by accessing the back of the tail light from behind by going through the trunk or by removing the entire assembly.
Do you need nitrile gloves to change tail light?
Before you begin – or if you have any questions about your specific vehicle – we always recommend taking a look at your service manual. Always wear nitrile gloves when handling bulbs as oils from your skin can damage the bulb and cause it to burn out prematurely.
How to replace turn signal lights and brake lights?
When you’re ready to put the assembly back in the housing, first hand-tighten the bolts before using a ratchet. It’s important to not tighten these too much, as they have a tendency to crack or break the housing. Replace the bulb holders. These should look different than the turn signal lights and brake lights.
Why does my tail light keep going out?
As you look around, you’ll notice that this isn’t an uncommon problem. Taillights fail frequently for many reasons. The bulb itself may have burned out, as these don’t last forever. There could faulty wiring or a disconnected wire somewhere. Accidents could cause the light to crack or break as well.