What does ignition signal primary mean?
The ignition coil primary circuit is turned on and off by the power transistor. The malfunction is detected when the ignition signal in the primary circuit is not sent to the PCM during engine cranking or running. Error code P1320 means there is a problem with the ignition coil or the wire to the ignition coil.
What does ignition signal mean?
This code is set when the ignition signal in the primary circuit is not sent to the PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) during engine cranking or running. Power from the ignition coil is supplied to the rotor.
How to read a malfunction code on Infiniti?
Wait two seconds, then rotate switch to full counterclockwise position. A malfunction code can be read as the long (0.6 second) blink, indicating the first digit of a two digit number and the short (0.3 second) blink, indicating the second digit.
Where is the diagnostic mode switch on Infiniti?
A second, though more time consuming method of clearing Codes involves using a small screwdriver to turn the diagnostic mode selector switch, located on the side of the ECM/ECU, fully clockwise. After waiting two seconds, rotate the switch to the full counterclockwise position.
Where are the fuses located on an Infiniti I30?
In this article, you will find fuse box diagrams of Infiniti i30 / i35 1998, 1999, 2000, 2001, 2002, 2003 and 2004, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Where is the diagnostic trouble code located on an Infiniti Q45?
On J30, M30 and Q45 models, the ECU is located behind the RH kick panel. If a malfunction occurs within the ECU/fuel injection system, a diagnostic trouble code may be stored in the ECU and the ‘‘Check Engine’’ lamp will blink. There is also a lamp built into the ECU which will concurrently blink. To read Code output, proceed as follows: