How to check engine codes on Polaris ranger 800?

How to check engine codes on Polaris ranger 800?

Engine Error Codes

1. If the error codes are not displayed, use the.
2. Press and hold the MODE button to enter.
3. Record the three numbers displayed in the gear position, clock and odometer displays.
4. Press the MODE button to advance to the next error code.
5. Press and hold the MODE button to exit the diagnostics code menu.

How to reset check engine light on turbo RZR?

To reset the computer drive in low range at 4000 rpm for around 30 seconds to a minute or until the engine light goes off. Then put in park shut off engine and wait a few seconds and restart. This should work till u get the new sensor.

How to clear RZR engine code?

Disconnect both battery terminals. Touch both terminals together and hold for 10 seconds. Reconnect to battery. That should do it.

How to check diagnostic trouble codes on Polaris ATV?

On my ’04 700 EFI it will display the specific code numbers. You do not need to read the flashes. You can run this mode even if there are no codes present. It will finish diagnostic mode with the word “END” if no codes IIRC. It appears on my XP there is no consumer method to enter diagnostics if there are no pending codes.

What does the trouble code 10 p0120 mean?

This Trouble Code sets if the Throttle Position Sensor Signal is below 0.7 Volts. Can be caused by Damaged Wiring, a faulty Throttle Position Sensor or ECU / Connections. 10 P0120 This Trouble Code sets when the Throttle Position Sensor Signal changes too rapidly to be correct.

When to know if your car has a trouble code?

This Trouble Code sets if the engine has been running above 3000 RPM for more than 2 minutes and the Exhaust Temperature Sensor Signal is below 0.06 Volts. Can be caused by Damaged Wiring, a faulty Engine Temperature Sensor or ECU / Connections.

What does trouble code 110 3 p0118 mean?

This Trouble Code sets if the Barometric Pressure Sensor Signal indicates an Unrealistic Rate of Change. Can be caused by Damaged Wiring, a faulty Barometric Pressure Sensor or ECU / Connections. Engine Temperature Sensor 110 3 P0118 ON This Trouble Code sets if the Engine Coolant Temperature Sensor Signal is above 4.8 Volts.

On my ’04 700 EFI it will display the specific code numbers. You do not need to read the flashes. You can run this mode even if there are no codes present. It will finish diagnostic mode with the word “END” if no codes IIRC. It appears on my XP there is no consumer method to enter diagnostics if there are no pending codes.

This Trouble Code sets if the Throttle Position Sensor Signal is below 0.7 Volts. Can be caused by Damaged Wiring, a faulty Throttle Position Sensor or ECU / Connections. 10 P0120 This Trouble Code sets when the Throttle Position Sensor Signal changes too rapidly to be correct.

This Trouble Code sets if the engine has been running above 3000 RPM for more than 2 minutes and the Exhaust Temperature Sensor Signal is below 0.06 Volts. Can be caused by Damaged Wiring, a faulty Engine Temperature Sensor or ECU / Connections.

This Trouble Code sets if the Barometric Pressure Sensor Signal indicates an Unrealistic Rate of Change. Can be caused by Damaged Wiring, a faulty Barometric Pressure Sensor or ECU / Connections. Engine Temperature Sensor 110 3 P0118 ON This Trouble Code sets if the Engine Coolant Temperature Sensor Signal is above 4.8 Volts.