Why do I have to parallel wire my RV batteries?
The wrong part is the load wires that connect the batteries to the RV are both placed on the same battery. This puts most of the pressure on the first battery and the least amount of pressure on the battery last in line. If you parallel wire your RV batteries like this the first batteries are going to wear out much faster than the other ones.
What should I do if my battery ground is not working?
If your accessory still doesn’t work properly after redoing the grounds, you will need a voltmeter or multimeter to trace the wiring. Set the voltmeter to read ohms (resistance) and probe the battery’s negative stud and ground connection on the accessory (the ground terminal on an amp, for example).
Can you wire two 6 volt batteries together?
You can do this by wiring two 6 volt batteries together in series by connecting a positive with a negative. When you do this you increase the voltage but not the amperage. For example, if you have two 12V 100ah deep cycle RV batteries and you wire them together in parallel you end up with 12 volts and 200ah.
Why do I get a draw on my battery?
This caused about a 0.7A draw in the battery through fuse 14 (which is not the radio fuse F36). In the process of trying to diagnose the issue I was getting confused by the transient nature of the current draw through the fuses by measuring the amperage on the fuse contacts (with the fuse pulled) or on the negative cable of the battery.
What should I do when I Disconnect my battery?
If there’s an underhood light unplug it or remove the bulb before disconnecting the battery. And don’t open the doors while the memory saver is plugged in.
Can a 9v battery be connected to the main battery?
Thanks! Second thought, directly connecting a 9v battery won’t work. It would need circuitry (diode, current limiting resistor?) to protect it from being literately blow to bits by the main battery during the time both are connected together. Very bad idea.
What should I do if I forgot to change the battery?
I forgot to add. If there’s an underhood light unplug it or remove the bulb before disconnecting the battery. And don’t open the doors while the memory saver is plugged in. If any lights come on with that nine volt battery, it’ll kill the battery and the memories will be lost.
Why is my anti lock braking not working?
The module of the anti-lock braking system can form corrosion after a while. This is actually one of the most common reasons for why there ends up being a problem with the anti-lock braking system. If the module is corroded, then it can’t obtain information from the wheel speed sensor.