How do you program a 2002 Pontiac Key?
Turn ignition to the ON position and back to OFF.
- Remove the existing key and within 10 seconds insert new key and turn it to the ON position.
- The security light will light up for 2 seconds to indicate successful programming of the additional key. Remove key from ignition.
- Insert key and start vehicle to test key.
Where is the ignition key lock cylinder located?
The ignition lock cylinder contains the pass-lock security chip that is extremely common to fail on the above vehicles. A typical symptom of failure is the security light illuminating on the dash. Also, keep in mind the electronic ignition switch is located just behind the lock cylinder.
How to program the ignition key on a Pontiac?
Cycle the key in the ignition to the “On” position and leave it in that position for 10 minutes and 30 seconds. Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
How to bypass the PassLock sensor on a 2002 Pontiac Grand Am?
This web page will guide you through the steps necessary to bypass the “Passlock Sensor” on a 2002 Pontiac Grand Am, and keep the “SECURITY” light off forever. The steps necessary are similar on the other models listed above. There are generally only minor differences in how to get the radio out to get to the wires.
How long does it take to turn off the ignition on a Pontiac?
Cycle the key back “Off” within 45 seconds. Repeat Steps 2 and 3 two more times, and then cycle the key back to the “On” position. Hold the key in the “On” position for five seconds, and use the key to start the car to end the process.
How to replace GM PassLock ignition key lock cylinder?
Press the small release tab (see pictures) While turning key to the ON Position Installation is the reverse of the above procedures, see below for the relearn procedure Clear all Diagnostic Trouble Codes (DTC). Record and/or repair your DTCs before clearing. You can clear the codes by disconnecting the battery for 10 minutes.
This web page will guide you through the steps necessary to bypass the “Passlock Sensor” on a 2002 Pontiac Grand Am, and keep the “SECURITY” light off forever. The steps necessary are similar on the other models listed above. There are generally only minor differences in how to get the radio out to get to the wires.
Is there a way to bypass GM security system?
Scouts Troop 980 of Utah cheers as their ’92 Olds Toronado is coming back to life. Thanks to the NEWROCKIES Full Bypass Module! How to FULLY bypass VATS Passkey and Passlock Security Systems in GM Cars. Has the dreaded GM Security system just hit you?
What kind of security system does GM use?
VATS, Passkey or Passlock – are the core of GM security systems, have a short lifespan and they’re certainly more effective at keeping you from DRIVING your car than keeping someone from STEALING your car! GM Security Systems are killing cars all over North America and the only final solution is to disable and remove them permanently.