Where is the relay wire for a fog light?
Connect one BLACK lead to the vehicle ground and to the relay terminal labeled 86. Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85. Test the operation of the lamps as follows: Re-connect the battery.
How to wire fog and driving lights harness?
Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp low beam lead. Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead.
Are there any instructions for installing fog lights?
We’ve covered the science behind how fog lights work, so now here’s a look at the hands-on side. Unfortunately, most fog light kits don’t come with instructions. With just a wiring diagram at best, you’re left with a pile of wires to figure out on your own.
Where to Mount Universal fog lights on car?
If you are using a universal fog light kit, the only changes are that you can skip step 10, and you get to choose where to mount your fog lights. See the guide in the link above for suggestions on mounting universal fog lights. Disconnect the negative battery terminal. Lay the wiring harness in the engine bay, approximating the layout you want.
Connect one BLACK lead to the vehicle ground and to the relay terminal labeled 86. Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85. Test the operation of the lamps as follows: Re-connect the battery.
Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead. Turn off the ignition and the headlamps. Disconnect the battery.
How do you wire a lamp to a relay?
Route the RED / WHITE wires from the lamps to the relay. Connect the RED / WHITE wire to the lamp terminals and to the relay terminal labeled 87. Connect one BLACK lead to the vehicle ground and to the relay terminal labeled 86. Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85.
How do you adjust a fog light on a car?
Loosen the mounting bolts to the vehicle to adjust the lights left and right. Position the vehicle on a flat surface at a distance of 25 feet (7.6 m) from a wall. Measure the distance from the center of the lamp to the ground and mark off the same height on the wall.