Where is the fuel pump located on a 2013 Jeep Wrangler?
The 2013 Jeep Wrangler fuel filter location is inside the gas tank. The usual cost for a Jeep Wrangler fuel pump replacement is between $778 and $884. Labor costs are priced between $230 and $287 while parts are priced between $558 and $607.
What happens when the fuel pump goes out in a Jeep Wrangler?
There are physical signs that you can feel when your Wrangler’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.
How do you drain a fuel tank in a Jeep Wrangler?
Disconnect the black, negative battery cable and loosen the filler cap. Drain the fuel tank through the filler hose using a hand siphon pump, if necessary. Loosen the wheel lugs on the rear, right-hand side tire and raise the rear of the vehicle using a floor jack and safely support it on two jack stands. Remove the tire and the wheel house liner.
What are the symptoms of a bad fuel pump?
Also, the symptoms are almost exactly the same as bad/clogged fuel filter. Here are the most common symptoms of a bad fuel pump in your Jeep Wrangler: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues.
Where is the fuel line on a Jeep Wrangler?
Unplug the electrical connector located on the left and front of the fuel tank and the two vapor lines next to the electrical connector by pressing the lock tabs. Disconnect the fuel supply line next to the electrical connector and the two vapor and overfill hoses next to the filler hose.
There are physical signs that you can feel when your Wrangler’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.
Also, the symptoms are almost exactly the same as bad/clogged fuel filter. Here are the most common symptoms of a bad fuel pump in your Jeep Wrangler: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues.
What do you need to start a Jeep Wrangler?
At the most basic of levels your Jeep Wrangler needs three things to start: Air, fuel, and spark . If any of these things aren’t present, the engine won’t turn over at all.
Where does the fuel pump go in a car?
In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s). It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do.