How to replace the CD player on a Mitsubishi Lancer?

How to replace the CD player on a Mitsubishi Lancer?

Using a Philips #2 screwdriver remove a 15 mm screw from the trim piece. Using both hands, carefully pull the trim outward section by section. The dashboard and decorative trim are attached to each other, so they will come out as one unit.

What to do when a fuse is blown on a Mitsubishi Lancer X?

Look through the clear side of the fuse to see if the metal wire inside is separated. If it is, the fuse is blown and should be replaced. Use a fuse puller (located in the engine compartment fuse block) to remove the fuses.

Where is the IoD fuse on a minivan?

The IOD fuse is located in the IPM (Intelligent Power Module – a fancy term for the main fuse box) which is in the engine compartment right next to the battery. The IPM lid pops off by releasing two tabs indicated on the cover.

What kind of Fuse is the IoD fuse?

The IOD fuse is a standard 15 amp blade fuse; there’s a diagram on the inside of the IPM lid showing the fuse positions. The fuse pulls straight up and out – no tabs or anything to release to remove it – and reinserts the same way.

Where are the fuses located on a Mitsubishi Lancer?

Keep in mind that the fuse designations can vary between model years and various trims. Located on the driver’s side of the engine is the main fuse box. The main fuse panel also has several relays. Under the dashboard on the driver’s side are located the interior fuses.

Using a Philips #2 screwdriver remove a 15 mm screw from the trim piece. Using both hands, carefully pull the trim outward section by section. The dashboard and decorative trim are attached to each other, so they will come out as one unit.

Where is the IoD fuse located in a car?

The IOD fuse is located in the vehicle’s engine compartment. It could be on either side of the dashboard or instrument panel, under the hood, or below the steering wheel. Refer to your vehicle’s fuse box diagram or this guide when locating or replacing the IOD fuse. Adventure seeker and off-road enthusiast.

When to disconnect the IoD fuse on a jeep?

A 2008 TSB instructed Jeep owners to do an IOD fuse disconnect for 10 seconds. If this step failed, the technician was to replace the WCM. These vehicles may show symptoms similar to a blown IOD fuse, so it is best to eliminate all other possible reasons before concluding that the IOD is the cause.