How to reset the security system on a 2003 pontiac grand am?

How to reset the security system on a 2003 pontiac grand am?

Turn the ignition key to the “Off” position for 10 seconds. 3. Repeat this process 3 times. This should reset the Security light/system and allow you to start your car.

How can I disable the alarm system on a 1997 Jeep Grand?

If there is the Honda added security box installed at the lower left side of the kick panel turn the ignition key to the on position. Locate the small button on the box and hold it down for 90 seconds and the alarm will bypass. Call to the dealer, this was their response: With the ignition key try to start the vehicle.

Why does my car not start when the Check Engine light blinks?

The sensor in the steering column is a coil shaped like a ring around the outside of the keyhole. This can become disconnected. However, if you have two chipped keys on the same ring, eg the spare, or the one for the other car (mine’s a Toyota ) they interfere with each other and it wont work.

Is it okay to drive with a flashing check engine light?

It’s never recommended to drive with a flashing check engine light. A constant check engine light can be okay to drive with sometimes, but a flashing engine light is most likely a more serious problem that has to be fixed as soon as possible.

What happens if a car security light is blinking?

If the security light is blinking the immobilizer system is enabled and will not allow the car to start. What Goes Wrong? Most cars today have a security system built into the electrical system (BCM – Body control module) to deter from theft. The problem is it can sometimes stop the person that owns the car from starting the engine as well.

Why does my Jeep Grand Cherokee have a flashing check engine light?

If you Grand Cherokee does start at all, it’ll run rough. It could be a more serious mechanical issue, such as as bent valve, bad lifter, etc…. We recommend that you don’t drive your vehicle if at all possible until you diagnose and fix your Grand Cherokee’s flashing check engine light.

The sensor in the steering column is a coil shaped like a ring around the outside of the keyhole. This can become disconnected. However, if you have two chipped keys on the same ring, eg the spare, or the one for the other car (mine’s a Toyota ) they interfere with each other and it wont work.

Why is the anti theft light blinking ON MY 2001 Ford Explorer?

Says there is no re-programming involved because it simply reads the chip and sends the info to the system. The last time my 2001 Explorer failed to read the chip I just bumped the steering wheel a couple times to send vibrations through the column. It worked.

It’s never recommended to drive with a flashing check engine light. A constant check engine light can be okay to drive with sometimes, but a flashing engine light is most likely a more serious problem that has to be fixed as soon as possible.