What is code 0014?
P0014 is the OBD-II generic code that the engine control module (ECM) has determined that the bank 1 exhaust camshaft is more advanced than what the ECM has commanded it be. This over-advanced condition could be during advancing or retarding of the camshaft timing.
Where are the camshaft sensors located on a Hyundai Sonata?
I have a 2009 hyundai sonata 2.4 motor does it have 2 camshaft sensor. Where are they at on the motor. Was this answer helpful? elynbert will be eternally grateful.
What does a code p0340 on a Hyundai mean?
A code P0340 Hyundai could mean one or more of the following has happened: a wire or connector in the circuit could be grounded/shorted/broken the camshaft position sensor may have failed the PCM may have failed there exists an open circuit the crankshaft position sensor may have failed
What causes a Hyundai Sonata to have p0014?
Here are the most common causes of P0014 in the Hyundai Sonata: Wiring Issues – If the wiring to the camshaft actuator has gone bad it can cause P0014. It’s good place to start diagnosing P0014. Is the harness connector plugged in?
What’s the trouble code for the Hyundai Sonata?
P0014 is a relatively common trouble code for vehicles that have Variable Valve Timing (VVT). This includes the Hyundai Sonata.
P0014 is a relatively common trouble code for vehicles that have Variable Valve Timing (VVT). This includes the Hyundai Sonata.
Here are the most common causes of P0014 in the Hyundai Sonata: Wiring Issues – If the wiring to the camshaft actuator has gone bad it can cause P0014. It’s good place to start diagnosing P0014. Is the harness connector plugged in?
How to find the p0014 position on a camshaft?
Type A code there is something else. P0016, P0017, P0018, P0019, P0335, P0336, P0338, P0341, P0342, P0343, P0346, P0347, P0348, P0366, P0367, P068, P091, P092, P093, P0521, P0522, P0523 If the initial P0014 sets and other codes are present then erase all codes and do five camshaft drive cycles and then re-investigate which codes come back.
What’s the target camshaft position on a Hyundai?
The target camshaft position is predetermined value depending on engine speed and throttle angle in the ECM . Need more information on how to fix the P0014 HYUNDAI code?