How to replace the front door panel on a Hyundai Elantra?
How to remove the interior door panels and replace the front door speakers in a 2011, 2012 and 2013 Hyundai Elantra.
How do you remove airbag from Hyundai Elantra?
Remove the airbag by using a screwdriver to press on the three locking pins that hold the Hyundai Elantra airbag in place. Next, you will need to remove the 21 mm nut that holds the steering wheel in place.
How do you remove battery cable from Hyundai Elantra?
To remove the cable from the battery post, you will need to loosen the 10 mm bolt. Wait at least 10 minutes before you start work on the airbag system. Remove the airbag by using a screwdriver to press on the three locking pins that hold the Hyundai Elantra airbag in place.
How to remove a tweeter speaker from a Hyundai Elantra?
The first step is to gently pry off the trim piece that covers the side view mirror nuts. In some vehicles, this trim piece may also contain a tweeter speaker. Then use the small flathead screwdriver to pry off the rectangular plastic screw cover behind the door pull lever. Remove the single Phillips head screw and set it aside in a safe place.
How to remove the interior door panels and replace the front door speakers in a 2011, 2012 and 2013 Hyundai Elantra.
How to change tail light bulb in 2013 Hyundai Elantra?
This video demonstrates how to change a burnt out taillight bulb on your 2013 Hyundai Elantra GT. Some of the other bulbs in the tail light cluster such as the brake light or turn signal may also function as the tail light in your Elantra GT.
When to replace the engine on a Hyundai Elantra?
Please try again later. 2013 Hyundai Elantra 1.8L short block replacement. Engine developed bottom end knock, found metal debris and bearing material in oil pan. Cam lobes, caps and cam carrier were found to be in good condition. Head and valves in good condition. Replaced short block assembly. Loading…
What was the 2013 Hyundai Elantra short block replacement?
2013 Hyundai Elantra 1.8L short block replacement. Engine developed bottom end knock, found metal debris and bearing material in oil pan. Cam lobes, caps and cam carrier were found to be in good condition. Head and valves in good condition. Replaced short block assembly. Loading…