How do you prime a Polaris fuel pump?
Priming the Fuel System
- Fill the fuel tank.
- Turn the ignition key to the ON position.
- Move the engine stop/run switch to the RUN position.
- Allow the fuel pump to run until it stops (about 2 seconds).
- Move the engine stop/run switch to the STOP position.
- Repeat steps 3–5 four to five times.
How do you prime a snowmobile?
The quickest and easiest thing to do is blow air into your gas tank. Forcing the fuel into the carbs, once the carbs are full, it will force some fuel up into the primer. pump the primer and watch the fuel lines. Some like to disconnect the output of the primer and pump until it comes out steady.
How do you check the fuel pump on a Polaris snowmobile?
To test the fuel pump, I remove the fuel line from one of the carbs and stick the line in a clear plastic bottle. Then I pull the rope a few times. There should be some gas spurt into the bottle on every pull of the rope. If there’s NO gas, you have an issue.
How do you manually prime a fuel pump?
How to Prime an Electric Fuel Pump
- Step 1 – Find the Fuel Pump. Make sure the car is off and make sure it has been sitting for at least a couple hours.
- Step 2 – Flip the Switch. There should be a prime switch located on the fuel pump line.
- Step 3 – Close the Hood and Clean Up.
- Step 4 – Test the Car.
How do you prime a snowmobile fuel pump?
For priming the system you’ll need to take the fuel line off that goes to the fuel rail on throttle bodies. then hook up battery, pump just enough to get the pump to labor a little. There is air in the lines and this will prime the system. Put the fuel line and pump connector back on and you will be good to go.
How many times do you prime a snowmobile?
i do mine every 1-2 years for piece of mind. if it starts getting flow by you’ll foul plugs and ruin your day.