How to wire up a taxi meter?
Attach the hot wire from the meter to a constant hot wire such as one from the fuse panel. Attach the ground wire to under dashboard on a good ground source. Run the pulse wire from the meter to the wire at the speed control. Wrap all exposed wires with electrical tape.
How do you turn off a taxi meter?
On the 32 Block F2 and F2 RTC meters the meter can be turned off by pressing the K2 and K4 buttons at the same time. The only exception to this is on the 4 Block F2 where the K1 button will turn the meter off. The meter can be turned on again by pressing the OP button. Select For Hire position.
What is the speed sensor wire for?
Your vehicle’s cruise control uses the VSS wire to determine the vehicle’s speed — it serves the same function for the navigation system. The VSS wire sends a series of pulses (from 800 to just over 1,000 per mile) only when the vehicle is in motion.
Where is the pulse wire for a taxi meter?
Run the pulse wire from the meter to the wire at the speed control. Wrap all exposed wires with electrical tape. Raise the bonnet of the vehicle and locate the speed sensor on the firewall.
Where do you mount a taxi meter on a car?
Locate the place on the dash for mounting taxi meter. This should be above the stereo or in the center near the passenger side of the dash board. Secure the mount to the dash attaching the screws with the flat-head screw driver. Raise the hood of the vehicle and locate the speed sensor on the firewall.
Where is the speed sensor on a car?
Color: Violet with White dot, Location: At ECM module near driver side shock tower under hood, the smaller connector. Also found Violet in Radio harness. Color: Dark Green, Location: Behind instrument cluster
Where is the speed sensor on a Camery?
Prius Hybrid, 2004 – 2009, Color: Violet/White, Location: At ECM module behind right side of dash. Camery Hybrid, 2012 and after, Color: Violet, Location: behind the stereo, on the upper first white connecter, pin 17. Camery Non-Hybrid, 2012 and after, Color: Blue, Location: At ECM under hood, the smaller plug, pin 17. Camery, 2007-2011,
Run the pulse wire from the meter to the wire at the speed control. Wrap all exposed wires with electrical tape. Raise the bonnet of the vehicle and locate the speed sensor on the firewall.
Locate the place on the dash for mounting taxi meter. This should be above the stereo or in the center near the passenger side of the dash board. Secure the mount to the dash attaching the screws with the flat-head screw driver. Raise the hood of the vehicle and locate the speed sensor on the firewall.
How much does it cost to install a speed sensor?
A sensor that rarely ever fails, but if it your vehicle is equipped with one of these and does fail expect the speedometer to fluctuate and the transmission to shift erratically. The cost of the part was 74 dollars, and took 30 minutes to install.
Color: Violet with White dot, Location: At ECM module near driver side shock tower under hood, the smaller connector. Also found Violet in Radio harness. Color: Dark Green, Location: Behind instrument cluster