How to replace alternator in Dodge Grand Caravan?
(Playback ID: 7_BGYrHNmxlVJCeF) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
How can I tell if my alternator is in high gear?
Start the vehicle and rev the engine to 2,000 RPM. This will draw power on your battery, which should cause your voltage regulator to kick the alternator into high gear. Keep the engine running and retest the battery with the voltmeter. When you read the voltmeter this time, the voltage should go up to at least 13.
What’s the best way to remove and replace an alternator?
Follow these simple, step-by-step instructions for removing and installing an automobile alternator with common tools. Includes advice on the correct wiring as well as testing and troubleshooting tips. Sponsored by BBB Industries – makers of premium alternators and starters that meet or exceed OE form, fit and function. http://www.BBBind.com
Do you need to check the battery first before checking the alternator?
Check the battery first. The battery is needed to start the vehicle, which, in turn spins the alternator at sufficient speed to keep the battery charged.
Where is the alternator on a Dodge truck?
Open the hood of your Dodge with the engine turned off. Also check to make certain that all other switches and/or electrical components have been turned off. Locate the alternator. Depending on your model of Dodge, the location will vary. It will, though, have a belt running to it.
What should I do if my alternator is not charging?
The alternator normally lasts longer than the battery. There are some easy steps you can go through to check the function of your alternator. Tap the alternator carefully with a hammer while the engine is runnin; if the charging goes back to normal, the coals inside it are worn out.
What causes a car alternator to stop working?
The alternator will stop working the moment your belt wears out and breaks or the pulley becomes damaged. These items are easy to replace. 3. Faulty fuse Fuses blow up due to a power surge or they wear out. When this happens, current will stop flowing to the alternator.
How can I tell if I have an alternator problem?
To differentiate an alternator problem from the battery, you will need to use a voltmeter to check for voltage. First, turn off the engine and check the battery voltage. A fully charged battery should have a reading of 12.65 volts. Next, turn on the engine and recheck the voltage. You should have a reading of 13.5 to 14.5 volts.
How can I tell if my alternator is charging?
The alternator is charging if the battery voltage stays above 13 volts with the engine at 2,000 rpm and all accessories on. Check the alternator gauge. If you have a volt/amp gauge, it will read the alternator output for you.
What’s the best way to replace an alternator?
If you find any of those issues, you’ll need to replace it. Remove the alternator from the engine bay. With the belt pulled off of the alternator pulley and the wires disconnected, the alternator should come out freely. You may need to wiggle the alternator around some things in order to remove it.
Can a low battery cause an alternator to go bad?
This means that if your battery is too low, you will be unable to start the vehicle and thus you will also be unable to test the alternator, rendering any additional voltmeter-testing totally useless. If the weather is cold or your battery is old, your battery could be the issue and your alternator might be just fine.
What should I do if my alternator is not working?
The solution is to check your car’s manual for the particular fuse that controls the alternator and replace it. In some cars, you might also find another small fuse to the alternator’s control—usually a 15A to 20A fuse. An alternator does usually has 3 or 4 wires to it to function properly.
Can you replace an alternator on a 2000 Jeep Cherokee?
Installing the drive belt over the new alternator is easily accomplished with two people, however, it can be done with one person. Replacing the alternator in your 2000 Jeep Cherokee can be done at home if you have some prior auto repair experience.
What kind of alternator does a GM 3.8L have?
This article covers the majority of 3.8L Buick, Chevy, Olds, and Pontiac equipped cars and mini-vans. To see if this alternator test article covers your specific 3.8L GM vehicle and alternator, you can take a look at the list of applications on the box labeled ‘Applies To:’ on the column on the right and scroll with the prev and next links.
How to test the alternator in a mini van?
So these are the steps: Start the car or mini-van and test the battery voltage with your multimeter by placing the RED multimeter’s test lead on the positive battery terminal and the BLACK test lead on the negative battery terminal. Your multimeter should read 13.5 to 14.5 Volts. If it doesn’t, don’t worry about this just yet.