How much fluid does a Harley transmission hold?
The transmission fluid capacity is approximately 24 ounces (0.71 liters). Inspect o-ring for tears or damage. Replace if required. Wipe any foreign material from plug.
When to replace the drain plug on a Harley Davidson?
If the engine oil or transmission oil drain plug allocation becomes stripped on a touring model, the entire oil pan may need to be replaced. This holds true for, both, Twin Cams and M8 Touring models. If the primary drain plug allocation becomes stripped, the inner primary case may need replacement.
Where is the transmission plug on a Harley Davidson Sportster?
The transmission drain plug on earlier model Sportsters. Locate the drain bolt (underneath the clutch on the bottom side of the chaincase) and remove it with a 5/8′ socket or wrench. Clean any material from the magnetic tip of the drain plug.
When to remove oil plugs on Harley Davidson?
It is of utmost importance to remove the engine oil and transmission oil fill plugs along with the primary derby cover; either before draining the oils or before the drain plugs are reinstalled. This will help to avoid confusion as to whether or not the oil has been replenished before attempting to start the motorcycle.
How do you change the transmission on a Harley Davidson?
Open the fill plug with a large flat head screwdriver or pry bar. Remove the transmission fluid level fill plug with a Allen wrench or socket. Level the bike and add fluid through the large fill plug opening until fluid pours out of the fluid level fill plug. Tighten down both fill plugs. Start the engine and check for leaks. Figure 4.
Where is the transmission drain plug on a Harley Davidson?
For this demonstration, we’re using a Harley-Davidson Softail, specifically a 2014 Fat Boy Lo. Locate the transmission drain plug, which can be a bit tricky. First, locate the two shock absorbers. The drain plus is located between the shock absorbers, underneath the transmission.
The transmission drain plug on earlier model Sportsters. Locate the drain bolt (underneath the clutch on the bottom side of the chaincase) and remove it with a 5/8′ socket or wrench. Clean any material from the magnetic tip of the drain plug.
How do you change transmission fluid on a Harley Davidson?
While the transmission fluid is draining, clean the drain plug. Make sure to remove all the debris and check the plug for damage. Slide the new O-ring onto the transmission plug and run it all the way to the bottom. Re-install the drain plug. Snug it up by hand, then use the torque wrench set at 14-21 foot-pounds torque to tighten it.
It is of utmost importance to remove the engine oil and transmission oil fill plugs along with the primary derby cover; either before draining the oils or before the drain plugs are reinstalled. This will help to avoid confusion as to whether or not the oil has been replenished before attempting to start the motorcycle.