Where is the start relay on a Harley Davidson?
It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
How to start a Harley Davidson that wont start?
Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL. 7) Turn on ignition ON and Kill switch to run. When you touch both of your installed wires together DOES bike crank./start? Click to expand…
Where is the fuse on a Harley Davidson?
Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL.
What does 12 volts mean on a start relay?
If you DID read 12 volts on your meter, you would immediately know the start relay was bad. If you did NOT read 12 volts, you would have to go back to the TSSM and hot wire (bypass it) in order to determine where the problem was.
Why is the fuel pump not working on my Harley?
Key fob battery was dead. Discovered that with a good battery in the fob when I turn ignition to on I can hear the fuel pump charging the system. When the fob is out of range everything works except the fuel pump. Hence the no start issue. Thank you a thousand times over. I spent Over two hours checking every electrical item I could.
What causes a Harley Davidson to not turn over?
If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.
Why does my Harley Davidson crank but not start?
There have been a few reports of a P1009 code – incorrect password also. It appears the turn signal and stalls or cranks but will not start. Try removing the ecm and security fuses, wait ten minutes and reinstall the fuses. This “reboots” the turn signal module and the motorcycle will then start from that point on.
What’s the voltage on a Harley Davidson starter?
I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.