Why are the fog lights not working on my Mercury Mountaineer?
Has anyone else seen this electrical problem in any of their vehicles before? I have a 2000 Mercury Mountaineer. When you turn the head lights on and have the fog lights on, the fog lights do not work at all. Also, the turn signals will not work with the fog lights on and the headlights on.
Why is the Check Engine light on on my mountaineer?
I have had my Mountaineer in the shop twice due to the check engine light being on as well as the Check fuel Cap. The dealer said that I was getting the messages in error and reset the computer. This works for a few weeks then the light comes back on. Is there anyway to fix the error message?
Where are the lights on the dashboard located?
Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch. Tail lights and dash lights are connected through the tail light (and/or brake light) fuse.
Why are the lights on my dash not working?
Flip the switch or turn the dial or knob up and see if the lights on your dash come on or get brighter. If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.
What to do if your Mercury Mountaineer won’t start?
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
How to reset an anti theft system for a Mercury Mountaineer?
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.
Has anyone else seen this electrical problem in any of their vehicles before? I have a 2000 Mercury Mountaineer. When you turn the head lights on and have the fog lights on, the fog lights do not work at all. Also, the turn signals will not work with the fog lights on and the headlights on.
What makes the brake lights go out on a mountaineer?
I have a ’98 Mountaineer and all three brake lights have gone out. I have checked the fuses and have 12V running threw the pedal switch. However, no voltage at the bulbs. Anyone have any ideas????? I have had my Mountaineer in the shop twice due to the check engine light being on as well as the Check fuel Cap.
What’s the outside temp on a 97 mountaineer?
I have a 97 Mountaineer that won’t crank when it is about 43 degrees or less outside. When you sit inside and go to crank it the THEFT light is flashing fast. When the outside temp reaches above 43 it cranks just fine. The other day I was driving down the road and the horn starts going off on its own intermittently.
What happens to spark plugs in FlexFuel mountaineer?
Is this just a loose wire? I recently discovered that when I used E85 fuel in my 2003 “Flexfuel” 4.0 V-6 Mountaineer, it destroyed the spark plugs in about 5000 miles, watered down the oil to the point of irreparable engine damage and gave me poor gas mileage.
I have had my Mountaineer in the shop twice due to the check engine light being on as well as the Check fuel Cap. The dealer said that I was getting the messages in error and reset the computer. This works for a few weeks then the light comes back on. Is there anyway to fix the error message?
I have a 97 Mountaineer that won’t crank when it is about 43 degrees or less outside. When you sit inside and go to crank it the THEFT light is flashing fast. When the outside temp reaches above 43 it cranks just fine. The other day I was driving down the road and the horn starts going off on its own intermittently.
Is this just a loose wire? I recently discovered that when I used E85 fuel in my 2003 “Flexfuel” 4.0 V-6 Mountaineer, it destroyed the spark plugs in about 5000 miles, watered down the oil to the point of irreparable engine damage and gave me poor gas mileage.
What are common reasons my Mercury Mountaineer won’t start?
What are common reasons my Mercury Mountaineer won’t start? While there are a variety of reasons your Mercury Mountaineer won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
What kind of fuel does a mountaineer use?
I recently discovered that when I used E85 fuel in my 2003 “Flexfuel” 4.0 V-6 Mountaineer, it destroyed the spark plugs in about 5000 miles, watered down the oil to the point of irreparable engine damage and gave me poor gas mileage. The vehicle was under warranty and the complete motor, throttlebody and fuel pump were replaced.
I have a ’98 Mountaineer and all three brake lights have gone out. I have checked the fuses and have 12V running threw the pedal switch. However, no voltage at the bulbs. Anyone have any ideas????? I have had my Mountaineer in the shop twice due to the check engine light being on as well as the Check fuel Cap.
What does the Mercury Mountaineer car alarm do?
The alarm on your Mercury Mountaineer acts as a theft deterrent. This anti-theft device may do more than just protect your vehicle from being stolen. Many insurance companies offer discounts on cars with alarm systems.
Do you need to reset the alarm on a mountaineer?
Many insurance companies offer discounts on cars with alarm systems. However, it’s not a perfect system. You may experience a false alarm, in which case you will need to reset your Mountaineer’s alarm. You must use the original key that came with the vehicle to deactivate and reset the alarm.
Why does my stereo not read my CD’s?
The stereo in my 1999 Mountaineer doesn’t read the CD’s very well The screen blacks out often and so does the temp/direction indicator above my re-view mirror. The CD’s wont read unless you put them in right when you start up the car or right after you eject a CD, and then sometimes it still doesn’t work.
What kind of warranty does Mercury gauges have?
If your builder or dealer uses genuine Mercury gauges and controls when installing the new engine on your boat, the warranty coverage for those rigging components now matches the total warranty of your engine. This means you could have up to an additional two years of control and rigging component coverage – based on the engine purchased.
What are launch profiles on Mercury smart tow?
Smart Tow Launch Profiles. Mercury Smart Tow can set the cruise speed as low as 8 mph, letting you create the perfect conditions for wake surfing. It comes with five launch profiles, and you can customize up to eight more – so you can personalize the ride to the rider.
Where is the parking brake release switch on a Mercury Mountaineer?
You can find it under the console towards the dashboard on the left side of your shifter. If the solenoid is working fine, check the parking brake release switch, which releases the shift lock actuator. The switch usually goes bad when you spill a drink down the parking brake. You will have to replace the broken component.
Where can I get replacement Mercury Mountaineer parts?
Mercury Mountaineer replacement parts can be obtained whether one needs Mercury Mountaineer performance parts, Mercury Mountaineer body parts, Mercury Mountaineer interior and exterior parts, and Mercury Mountaineer auto accessories.
When was the last year of the Mercury Mountaineer?
In 2006, the V8 engine received a power boost of up to 292 hp and was matched with a six-speed automatic transmission. The Mountaineer’s performance and fuel economy improved due to these enhancements. However, the 2010 model year marked the Mountaineer’s final year, as the Mercury brand was to be phased out for 2011.
What kind of engine does a Mercury Mountaineer have?
The 2004 Mountaineer came with stability control as an option, which considerably raised its safety quotient. A year after, this feature was made standard. It came packaged with a Roll Stability Control. In 2006, the V8 engine received a power boost of up to 292 hp and was matched with a six-speed automatic transmission.
Where are the fuse panels on a Mercury Mountaineer?
Here you will find fuse box diagrams of Mercury Mountaineer 1997, 1998, 1999, 2000 and 2001, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Can a turn signal work with fog lights on?
Also, the turn signals will not work with the fog lights on and the headlights on. I could only get the turn signal to work with the running lights on. Another thing is that with the lights on and the fog lights on, the left headlight/ fog light would be really dull. and the left turn signal light stays on.
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.