Why would a spark plug wire pop out?
If the plug is even slightly loose then combustion gasses will create pressure in the well and pop off the wire. There is an air pocket around the spark plug in these wells. This air heats up and expands. If the plug wire is not vented it will pop off while driving the vehicle.
How to turn on ignition on Honda CBR 600 F4i?
• Check cylinder compression and check that the spark plugs are installed corrcctly. Disconnect the direct ignition coils from the spark plugs (page 3-6). Connect the direct ignition coil 2P connectors to the direct ignition coil. Shift the transmission into neutral.
Where are the spark plugs on a Honda CBR 600?
Disconnect the direct ignition coils from the spark plugs (page 3-6). Connect the direct ignition coil 2P connectors to the direct ignition coil. Shift the transmission into neutral. Connect known-good spark plugs to the direct igni tion coils and ground the spark plugs to the cylinder head as done in the spark test.
What kind of battery does CBR 600 F4i have?
Zener Diode – The pink wire in the ignition reads 8.6V. I also pinned this at the ECU and I also got 8.6V. 3. Ignition Switch – works properly in all positions according to the manual (checked continuity). 4.
What is peak voltage adaptor for Honda CBR 600 F4i?
Peak voltage adaptor 07HGJ-0020100 (Not available in U.S.A.) with commercially available digital multimeter (impedance 10 MQ/DCV minimum) • Inspect the following before diagnosing the system.
• Check cylinder compression and check that the spark plugs are installed corrcctly. Disconnect the direct ignition coils from the spark plugs (page 3-6). Connect the direct ignition coil 2P connectors to the direct ignition coil. Shift the transmission into neutral.
Disconnect the direct ignition coils from the spark plugs (page 3-6). Connect the direct ignition coil 2P connectors to the direct ignition coil. Shift the transmission into neutral. Connect known-good spark plugs to the direct igni tion coils and ground the spark plugs to the cylinder head as done in the spark test.
Peak voltage adaptor 07HGJ-0020100 (Not available in U.S.A.) with commercially available digital multimeter (impedance 10 MQ/DCV minimum) • Inspect the following before diagnosing the system.
What happens when you disconnect the ECM on a Honda CBR 600?
Faulty ECM (in case when the initial voltage is normal while disconnecting ECM connector) Initial voltage is normal, but it drops down to 2 – 4 V while cranking the engine. 1.