Why my harley won t start?
If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter. If the motor cranks and still won’t start, then it is likely a fuel or spark issue. A few tests can be performed to quickly track down the problem.
When did Harley switch to Delphi?
2001
With all the changes in 1999-2000, things were quite at Harley-Davidson for a few years, though in 2001 they switched to a better, Delphi EFI system on the bikes that were injected. 2001 was also the first year the Softail line was available with a fuel injected motor.
What’s the problem with the fuel pump on a road King?
I have a 2000 Road King Police FLHPI. Problem I am having is with fuel pump. I turn the ignition and hear the pump whine. Hit the start button and it fires up. Ride it just a block or so and it dies. (engine dies but all lights etc are still on)
How do you remove a fuel pump from a Harley Davidson?
Gently pull the front seat towards the rear and up. Consult your owner’s manual and locate the fuse box. Remove the fuse for the fuel pump. Your owner’s manual or a chart on the fuse box cover should indicate which one. Once the fuse is removed, start your engine and let it run until the engine dies.
Can a fuel filter be replaced on a road King?
Going into the fuel tank is easier than you think. The only difficult part is getting the fuel filter assembly to pivot. Search videos on YouTube there’s many on how to do it. Replace the check valve/line assembly, fuel filter kit at the same time. You should be able to reuse all gaskets and screws.
What does no start, no fuel pump mean?
Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good. Any other ideas? No start, no spark, no fuel pump. working on my 2008 screaming eagle ultra classic that I just got. Engine is a no start.
I have a 2000 Road King Police FLHPI. Problem I am having is with fuel pump. I turn the ignition and hear the pump whine. Hit the start button and it fires up. Ride it just a block or so and it dies. (engine dies but all lights etc are still on)
Going into the fuel tank is easier than you think. The only difficult part is getting the fuel filter assembly to pivot. Search videos on YouTube there’s many on how to do it. Replace the check valve/line assembly, fuel filter kit at the same time. You should be able to reuse all gaskets and screws.
Why is my fuel pump not working on my Harley?
If you could get a voltage at the relay on the coil side of the relay, it would tell the story. Of course you need to disconnect battery cables at both ends clean, and tighten, Same for grounds remove, clean tighten. Sure sounds like a vibration issue more than a heat issue.
Can you run the gas pump while out of the tank?
Run the pump while out of the tank, just put the pickup in a supply of fuel, plug the end of the pressure regulator. You should hear how healthy it is running on bench. but never completes the full “whine cycle”.