Why is UniFi connected but no Internet access?
check your modem got any un-normal LED (red or other). sometime is modem no incoming so even you connect wifi also no internet. if modem got problem , then you need call 100 or livechat , so they can send someone to help.
Why is my UniFi WiFi so slow?
Channel width is the most common cause for poor speed test results after setting up UniFi, especially when being compared to a single wireless router the UniFi devices are replacing. We do not recommend that channel width be increased from 20 MHz on 2.4GHz as this will often cause worse performance.
How do I optimize my UniFi Network?
5 Ways to Improve UniFi Wi-Fi Performance
- Check your Frequency. The first thing to take a look at is the frequency/channel that is being used for your wireless coverage.
- Check the Channel Width.
- Adjust Transmit Power.
- Enable Band Steering.
- Adjust Cell Size and RSSI Thresholds.
- 5 Ways to Improve your Ubiquiti Wireless Links.
Why my Unifi suddenly stopped working?
An incorrectly designed network might be one of the causes of UniFi device connectivity issues. If moving closer to the access point that your client is connected to resolves the issue, you might need to reassess the types, locations or the number of your UniFi Access Points.
How do I fix Unifi slow Internet?
My internet is very slow
- Restart your mobile phone.
- Check to ensure you are connected to unifi network.
- Ensure the Signal Level is good.
- Wait for 10 minutes and try again.
- Clear application cache and stop all background apps.
- Close and re-launch the application.
- Make sure mobile phone internal space is not full.
How do I increase my upload speed on Unifi?
How to increase your upload speed
- Try using a wired connection.
- Clear your temporary files.
- Remove other devices from your network.
- Remove malware.
- Change your DNS settings.
- Update device drivers.
- Upload at off-peak times.
How do I fix Unifi slow?
What is RF scanning Unifi?
-If you have a unifi AC AP first thing to do is an RF-Environment scan. It will show you what is the best channel for you to use. It will show you where is the least noise and where the least utilization is. That’s where you want to put your channel.