Why is my Polaris digital display not working?
My PIDD (Polaris interactive digital display) has stopped working. It first started to act up and flicker when booting. I would restart sled and the display would work again. But now its black all the time. Tried to supply 12v dc with a batteri to the “Gauge pwr test” connector above left shocktower, the display works fine then.
What was the speed of Speedo in 2013 Polaris?
Started my 2013 800 Polaris Adventure today for first time this year and speedo was bouncing around to all different speeds while sled was standing still. I then went for a short ride and at one time stopped speed went to 113 mph. It appears tach is bouncing around too but temp was not.
Are there any recalls on Polaris snowmobiles?
Washington, DC – Consumers should stop using this product, which is being recalled voluntarily, unless otherwise instructed. It is illegal to resell or attempt to resell a recalled consumer product. Hazard: The bolt attaching the front, lower left shock can fail and cause the operator to lose control of the vehicle.
Where are the numbers on a Polaris snowmobile?
The snowmobiles come in red, white and black. “Pro-RMK” is on the lower right and left sides of the hood. The engine size and the letters “ES” or the words “Limited Edition” are on the upper right and left sides of the hood. The numbers “155” or “163” are on the rear of the tunnel.
Is the 2013 Pro RMK 800 high idle and no reverse?
Have a great season. From this point on, all vendors/mfg’s promoting Pre-Season tiered sales programs, in the Polaris Forums, that are not paid advertisers will be appropriately moved to the swapmeet section of the forums. 2013 Pro RMK 800 High Idle and No reverse?
What kind of compression does a 2013 RMK 800 have?
Its got 125 psi compression per hole and aftermarket can and 1500 miles on the clock. It starts on 2 pulls and immediately the digital gauge shows “9 – non” or something like that for a split second and then goes to normal rpm and stuff. Wondering if this is normal or a code I should check?
My PIDD (Polaris interactive digital display) has stopped working. It first started to act up and flicker when booting. I would restart sled and the display would work again. But now its black all the time. Tried to supply 12v dc with a batteri to the “Gauge pwr test” connector above left shocktower, the display works fine then.
What’s the part number on a Polaris fuel gauge?
Polaris part number is 5437046 Common problem with the material that was used for the float on the arm is for it to get saturated and no longer float. But it will sometimes. It’s like a hard cell foam, replace it and you’ll be reading properly.