Why is my Mazda 6 immobiliser light not flashing?

Why is my Mazda 6 immobiliser light not flashing?

Re: Mazda 6 immobiliser light flashing and car will not… Immobilisers may intercept one of three circuits; typically the low-voltage ignition circuit and the fuel pump circuit. Some may also intercept the low-current starter motor circuit from the key switch to the relay.

Why does my Mazda not start when I Turn on the ignition?

If when you turn on the ignition, the “Security” light stays on or flashes, it means that your car’s security system does not recognize the key or that there is a problem with some parts of the security system itself. Sometimes the key just needs to be reprogrammed.

Why does my immobilizer light flash when I Turn Off the starter?

There were two things that caused this. One: when Best Buy installed the remote starter last year they crack an internal antenna in the immobilizer module. And two: one of the wires leading to the starter was corroded and allowed current to flow sporadicly. The red key light always is supposed to flash when the car is off and the key is removed.

Why does my Mazda 3 not start when parked?

The starter itself or a starter solenoid may be faulty. A problem with a neutral safety switch. If a car does not start with the transmission parked, but starts in neutral, it may be due to a problem with a neutral safety switch or the shift lever cable.

Re: Mazda 6 immobiliser light flashing and car will not… Immobilisers may intercept one of three circuits; typically the low-voltage ignition circuit and the fuel pump circuit. Some may also intercept the low-current starter motor circuit from the key switch to the relay.

What to do if your Mazda car won’t start?

You can’t post conmments that contain an email address. With the new lock cylinder in it, turn the key on. The security light should blink. Leave the key on for 10 minutes, the security light will quit blinking and go out after 10 min. This will reprogram your security system and the car should start.

What to do if your Mazda security light goes out?

Leave the key on for 10 minutes, the security light will quit blinking and go out after 10 min. This will reprogram your security system and the car should start. Also leave a battery charger on it while the key is on, If the battery goes dead during the 10 minute reprogram sequence, you will have to start over again.

There were two things that caused this. One: when Best Buy installed the remote starter last year they crack an internal antenna in the immobilizer module. And two: one of the wires leading to the starter was corroded and allowed current to flow sporadicly. The red key light always is supposed to flash when the car is off and the key is removed.