Why is my GMC Canyon crew cab not working?

To find out once it crapped out, my 2006 GMC Canyon Crew Cab had the original battery. I replaced it last week with a brand new battery. Over last summer the battery went dead from sitting around for long periods of times. Thats when we found out the power door locks and drivers window wouldnt work.

Why are the locks not working on my Chevy Colorado?

Anyhow, turns out my battery was fine, but when I reconnected it the driver’s side window would not go up or down, and the power locks would not work. Pressing either button on the key fob would flash the headlights, and you could hear a relay under the hood clicking, but nothing on the locks.

What happens to the battery in a Chevy Colorado?

The part I love is how the truck always dings and throws battery is codes when its cold out, and how the truck goes from 1/2 a tank to empty when you tap the brakes of shift into neutral.

Are there power door locks on a 2006 Chevy Colorado?

2006 Chevy Colorado, installed new battery now power door locks do not work, and driver side window. Check to see if any 2006 Chevy Colorado: power door locks..driver side window… 2006 Chevy Colorado, installed new… 2006 Chevy Colorado, installed new battery now power door locks do not work, and driver side window.

Where is the relay on a canyon four door?

Same thing happened to my 04 Canyon four door after I disconnected the battery to replace the vent solenoid for the charcoal canister. There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch.

Where are the power locks on my car?

There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch. It can get stuck open, either from the BCM sending it into safe mode or, in my case, I think, because of extreme cold.

Why does my Colorado window lock not work?

The resistor and connector is an easy fix with the link ssgjurista gave you. I think the problem is the contacts between the two most times rather than the resistor itself.

How to fix a 2005 Chevy Colorado door lock?

Click to expand… I also have a 2005 Chevy Colorado with the exact same problem. I followed the advice given, that is removing the negative battery cable and holding it against the positive terminal on the battery for 30 seconds to completely discharge the BCM (body control module) and waiting 6 hours then reconnecting the battery cable.

Why are the windows not working on my Chevy Colorado?

Trying to narrow down the possibilities. If all controls are not working it could be a power supply problem. If only one side of the truck is inop, it could be a ground issue. When the windows are not operating, do the door locks still function, using the switches?

What to do if your driver side window does not work?

Shut the truck off and start again. Put in gear and you should hear the door locks activate again and your driver side window should work again. If that doesn’t do the trick, unplug the black harness again (with the ignition off), spray wd40 into any connection that has corrosion and blow connection clean with air.

Why is my window fuse not working on my Chevy Colorado?

Check the 30A PWR/WINDOW fuse and socket for possible corrosion. Maybe try using some contact cleaner and a new fuse. Make sure that the fuse fits tightly in the contacts. Still having problems with windows. Seems worse, probably cause of warmer temp.

Why does my drivers side window not work?

A smaller version of GM’s rebirth of the Hummer. Hard to start yesterday,drivers side window,power door locks wont work,either by buttons on both doors or on key fob.Other windows work! Replaced Battery checked door lock fuse,still no drivers side window or door locks. Answered! View the answer I have this problem too Is this a good question?

Why does my driver side door lock not work?

The windows and the locks are on two separate circuits. The only part that these two have in common is the master switch. Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact.

Why does my Chevy Colorado Charger not charge?

A cold battery will not charge so the initial voltage (and current) is converted internally to heat to warm up the battery. This why you can get by a with a little higher charging voltage for accelerated battery warm up when the vehicles first started. As the battery warms up the charging voltage must be reduced into the 13.8 to 14.2 range.

Can a car battery be disconnected while the engine is running?

Battery voltage MUST be maintained to the (PCM) and other modules; while the battery is disconnected. NEVER : disconnect the car battery; while the engine is running or the ignition key is turned on. Automotive Car Battery With Negative Cable Removed

Navigation