Why does my Yukon Denali make scraping noise?
Thanks everyone. 2004 Yukon Denali came home with wife yesterday. Scraping noise from the front drivers side hub. Turns out that the hub nut need to be tightened. Not sure why but ok. The scraping continued to the end of the driveway and has not returned.
Why does traction control come on on my Yukon Denali?
2004 Yukon Denali came home with wife yesterday. Scraping noise from the front drivers side hub. Turns out that the hub nut need to be tightened. Not sure why but ok. The scraping continued to the end of the driveway and has not returned. After taking care of that, the ABS warning light and the Traction Control warning came on at the same time.
Why are my brake pads still squeaking after replacing them?
Ensure the shims are replaced too. Another cause of brake noise after new pads and rotors is a faulty wheel bearing. So if you hear the grinding noises from your wheels, brakes still squeaking after replacing pads and rotors or observe vibrations which alternate from quiet to loud, then it means you may have a worn-out or damaged wheel bearing.
Why does my car make a grinding noise when I brake?
Sometimes your brake system might have debris from outside that stays in it, and this debris could be little pieces of rock or gravel that gets stuck in the caliper. And sometimes the debris will rest between the rotor and caliper, which will cause scraping or grinding noises that will occur and possibly vibrates.
Sometimes your brake system might have debris from outside that stays in it, and this debris could be little pieces of rock or gravel that gets stuck in the caliper. And sometimes the debris will rest between the rotor and caliper, which will cause scraping or grinding noises that will occur and possibly vibrates.
Ensure the shims are replaced too. Another cause of brake noise after new pads and rotors is a faulty wheel bearing. So if you hear the grinding noises from your wheels, brakes still squeaking after replacing pads and rotors or observe vibrations which alternate from quiet to loud, then it means you may have a worn-out or damaged wheel bearing.
What causes brake noise after new rotors and pads?
One of the major cause of brakes noise after new pads and rotors is having excess brake dust that is trapped between the caliper and the rotor.
Is there a grinding sound in the front?
Front Grinding Sound . . OK. 2002 4WD Yukon. Again. You’re all probably tired of hearing about it. I had a front end grinding sound noticeable when slowing to a stop. Couldn’t tell which side exactly, but it is in the front.
Why does my Chevy Tahoe make a humming sound?
Replaced both front hubs, and all has been well since. My ’04 Tahoe makes a humming sound from the front wheel area, but only at low speed excessive turns, like turning sharp out of a parking spot. it is the same sound that happens when the traction control and ABS kickin on ice.
Why does my GMC Yukon make a grinding noise?
HEY THERE, I TOO HAVE THE SAME PROBLEM WITH MY 2002 DENALI AND TOOK IT INTO THE DEALER ABOUT 4 TIMES AND ALWAYS WAS UNABLE TO GET AN ANSWER. RECENTLY AT THE GMC DEALERSHIP, I WAS TOLD THAT THE NOISE (GRINDING AND POPING) WAS COMING FROM THE STEERING SHAFT.
Why does my car make a grinding noise when I press the gas pedal?
It sounds like a whining or grinding sound (sounds like its fron right under the driver seat) but only if the gas pedal is pressed. Lay off the gas, and coast, and it stops after aout a second. Press the gas, and it comes back.
Why does my Chevy Tahoe make a whining noise?
The pinion bearings can make faint droning or whining noises at higher speeds on the 10 bolt rear axles. The pinion bearings can make faint droning or whining noises at higher speeds on the 10 bolt rear axles. Click to expand…