Why does my truck smell like metal?
Burning Metallic Smell: This usually means your brakes are wearing down, or your clutch is failing. The clutch disc and your brake pads are similar in composition, and both create a similar smell. Bring your vehicle in to the service center to diagnose the issue and replace the affected part.
Why does my Mitsubishi L200 heater smell like antifreeze?
For a couple of weeks the distinctive smell of antifreeze along with fogging of the interior window surfaces when the heater was used – spell the tell tale signs of the heater matrix leaking.
What to remove from a Mitsubishi L200 heater?
Remove the upper and lower plastic air ducts that connect air passages from the heater box to dashboard sections and foot area. From the engine compartment on the firewall, remove the two hose clips and slide off the hoses from the protruding heater matrix pipes.
When does Mitsubishi L200 Warrior engine management light come on?
700mls with the new L200 Warrior Engine Management light comes on goes into limp mode 3 days at Mitsubishi garage and st… on the dash showing drive mod when in 2wheel drive the front wheels still flashes but still drives should these go off …
Where is the air bag plug on a Mitsubishi L200?
Pry out the cover panel from the bottom, remove the two 10mm pins that hold the bag module to the crossbar plate. Lift up the green tab on the red electrical connector and remove the air bag plug from its socket.
For a couple of weeks the distinctive smell of antifreeze along with fogging of the interior window surfaces when the heater was used – spell the tell tale signs of the heater matrix leaking.
Remove the upper and lower plastic air ducts that connect air passages from the heater box to dashboard sections and foot area. From the engine compartment on the firewall, remove the two hose clips and slide off the hoses from the protruding heater matrix pipes.
Pry out the cover panel from the bottom, remove the two 10mm pins that hold the bag module to the crossbar plate. Lift up the green tab on the red electrical connector and remove the air bag plug from its socket.
How long does it take to replace matrix in Mitsubishi L200?
For a rough guide, including the under bonnet work to release the feed and return hoses to the matrix and topping up the coolant system, expect in the order of 6 hours work to complete the task.