Why does my scooter run when the brake switch is closed?
If the scooter runs when the controller’s brake switch connector terminals are bridged together then the brake switch is a normally closed type which is faulty. (No Tools Needed) Test the key switch or power switch for proper mechanical operation by moving it from the off position to the on position several times.
Is the GY6 150cc ignition system easy to troubleshoot?
This guide covers almost any of the 150cc buggies, scooters, or ATV’s with the standard “AC” CDI setup. The first version was downloaded over 136,494 times and we’re happy that this information continues to help so many people! The 150cc GY6 ignition system is fairly easy to troubleshoot in the case of malfunction.
What’s the problem with my GO GO scooter?
Condition: The throttle or potentiometer or the speed pod has malfunctioned. Solution: Contact Statewide Mobility to replace both devices at a low cost. Condition: The Go Go scooter’s motor has been disconnected. Solution: Contact Statewide Mobility for further assessment of your mobility scooter.
How many windings does a GY6 150cc have?
Don’t use force here. Depending on your stator type, you have either 6, 8, or 11 windings. Of these windings, one is dedicated to supplying the CDI with ignition power. This winding is usually wrapped in white cloth material and sealed over with clear epoxy.
If the scooter runs when the controller’s brake switch connector terminals are bridged together then the brake switch is a normally closed type which is faulty. (No Tools Needed) Test the key switch or power switch for proper mechanical operation by moving it from the off position to the on position several times.
How to troubleshoot an electric scooter with a circuit breaker?
For scooters that use a circuit breaker, push-on or flip the circuit breaker to see if it will reset. Electric scooters with single speed throttles sometimes need to be pushed forward in order to run. Stand on the scooter with one foot and push it forward with your other foot while fully engaging the throttle.
Why is the idle speed on my scooter not working?
Brake adjustment could be too tight (drum-type brakes) or too much brake fluid in a reservoir on disc brake models. Engine idles but then dies. This is normal for the initial startup. If the problem persists the idle speed may need to be increased. The idle speed adjustment screw is on the right side of the carburetor.
Can a faulty ignition cause a scooter to not run?
Faulty ignition timing can cause running problems but today there are very few scooter engines on which you can alter or adjust the ignition timing. All timing functions are done electronically via the CDI (Capacitor Discharge Ignition) module.