Why does my Santa Fe engine not Rev?
Santa fe idles but will not rev above 2000 rpm’s – won’t take a load. I received a cylinder 4 misfire code awhile ago, so I replaced an ignition coil and the code went away and now there is no code at all. The engine idles fine no issues there, but as soon as you rev the engine it starts to miss and sounds like its suffocating.
Why does my Hyundai Santa Fe not accelerate?
Here are the most common cause of acceleration with the RPM’s going up: 1. Transmission Fluid Low. If your Santa Fe is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.
Can a Santa Fe car take a load?
Santa fe idles but will not rev above 2000 rpm’s – won’t take a load. I received a cylinder 4 misfire code awhile ago, Santa fe idles but will not rev above 2000 rpm's – won't take a load. I received a cylinder 4 misfire code awhile ago, – Answered by a verified Hyundai Mechanic
What’s the RPM limit on a Santa Fe?
Santa fe idles but will not rev above 2000 rpm's – won't take a load. I received a cylinder 4 misfire code awhile ago, – Answered by a verified Hyundai Mechanic We use cookies to give you the best possible experience on our website.
Here are the most common cause of acceleration with the RPM’s going up: 1. Transmission Fluid Low. If your Santa Fe is too low on transmission fluid, it’ll will no longer be able to transfer power to the rear wheels. The power goes to the torque converter, and that’s the end of the line. You should check the transmission fluid immediately.
How many miles does a Hyundai Santa Fe have?
I have a 2004 Hyundai Santa Fe with just under 97,000 miles on it. It’s a V6, 3.5L, AWD. I’m the second owner (parents were the first).
How can you tell if a car has no power?
What you actually describe can be read in at least 3 different ways. One is that you’re hitting the gas, but the engine itself has no power. It might run roughly. The rpms won’t get very high. It might sound like its bogging down or something.
What causes a Ford Expedition to not accelerate?
When the clutch can’t hold on anymore, it’ll start to slip. Slipping means that it loses its grip on the flywheel and it feels like you’ve pushed the clutch in. This will usually happen at highway speed, under heavy acceleration. It only gets worse as the clutch disk slips, burns up, and can handle less and less torque.
Where was the Hyundai Santa Fe engine shut off without warning?
While driving approximately 70 mph, the vehicle shut down without warning. The engine was restarted and the vehicle was towed to an unknown dealer in jackson, TN. The manufacturer was made aware of the failure and stated there was no recall.
What causes rough idle on a Hyundai Santa Fe?
On the 2.7L V6 and 2.4L 4 Cylinder, a defective exhaust gas recirculation (EGR) switching valve may cause an intermittent rough or unstable idle engine. The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111.
Santa fe idles but will not rev above 2000 rpm’s – won’t take a load. I received a cylinder 4 misfire code awhile ago, so I replaced an ignition coil and the code went away and now there is no code at all. The engine idles fine no issues there, but as soon as you rev the engine it starts to miss and sounds like its suffocating.
Are there any problems with the Hyundai Santa Fe?
Hyundai Santa Fe owners have reported 45 problems related to engine shut off without warning (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Hyundai Santa Fe based on all problems reported for the Santa Fe.
Santa fe idles but will not rev above 2000 rpm’s – won’t take a load. I received a cylinder 4 misfire code awhile ago, Santa fe idles but will not rev above 2000 rpm’s – won’t take a load. I received a cylinder 4 misfire code awhile ago, – Answered by a verified Hyundai Mechanic