Why does my rear turn signal not flash?
Rear signals are still hooked up but don’t flash.. yes, bsmith. most likely they don’t work because they aren’t hooked up , up front. ypu can wire a resistor inline to remedy that. yes, bsmith. most likely they don’t work because they aren’t hooked up , up front. ypu can wire a resistor inline to remedy that.
Why does my Dyna FXDC bike not start?
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.
Why does my Moco turn signal not flash?
Mine still flashes (1995) but no longer cancels. As well, there’s a diagnostic test that can be done to the turnsignal module, because if it loses it’s ground, it fails to work correctly as well….. if you have a Moco repair manual, it’s in the manual. If not, then hit me up and I’ll try to simplify it and PM you with it. Click to expand…
Where are the turn signals on a Harley Davidson?
Locate the connector under the left side cover that has the brown and violet wires , those are the turn signal wires . Install the directionals and wire them into the brown and violet wires . Disclaimer : Don’t believe anything I say unless you are absolutely sure that I know what I’m talking about .
When do turn signals flash, bike won’t start?
Re: Turn signals flash, bike won’t start, no key fob with… If you turn signal flashing,then your security system is on. You will need the key fob for starting.,or change the Bat on Key Fob. You can’t post conmments that contain an email address.
Why do the lights keep flashing on my Harley Davidson?
It’s when the fob is out of range and the bike is “disturbed” a bit and the security activates by flashing the lights like it is supposed to do but the dang lights just keep flashing till I get my fob out of the house and take it close to the bike. Have you tried to turn off the security system and turn it back on.
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.
What does it mean when your turn signal flashes?
If you turn signal flashing,then your security system is on. You will need the key fob for starting.,or change the Bat on Key Fob. You can’t post conmments that contain an email address. 883 sportster 2007, bike will start on compression but will not start with switch, speedometer needle is stuck and flashers does not work.