Why does my radio not work in my car?
For instance, if your radio turns on and displays a station, but no sound comes out of the speakers, then it’s probably an issue with the speakers or the wiring or even the antenna. In that same vein, a car stereo with a non-functioning radio may be tracked down to an antenna problem if other audio sources, like the CD player, work just fine.
When does the power antenna stop receiving power?
But in newer vehicles, the power antenna may only be receiving power when the radio is in AM/FM mode. If you switch to Aux input, CD, satellite radio, etc… the power antenna wire will stop receiving power and your amplifier will power down as a result.
Do you wire your remote turn on to power antenna?
Do NOT wire your remote turn on to power antenna in newer vehicles: In older vehicles, wiring remote turn on to power antenna was very common and worked just fine because when the radio was on, the power antenna was up and working. But in newer vehicles, the power antenna may only be receiving power when the radio is in AM/FM mode.
What should I do if my car stereo wont turn on?
Trace back wiring from the car stereo’s control head power harness to the fuse block and verify that the wiring is all intact. If you encounter a fuse along the red wire, replace it. The black wire may well go straight to the car body—it’s the ground.
For instance, if your radio turns on and displays a station, but no sound comes out of the speakers, then it’s probably an issue with the speakers or the wiring or even the antenna. In that same vein, a car stereo with a non-functioning radio may be tracked down to an antenna problem if other audio sources, like the CD player, work just fine.
Can a power antenna be left in the air?
If you connect it to the ones that get 12 volts when key is in Acc or On, it will work fine with the exception that when you shut off the engine and pull the key, the antenna will be left in the air because it doesn’t have any power to drop.
What to do if your car power antenna is not removable?
If your antenna doesn’t have a removable coaxial connector, disconnect the power connectors and perform the mast replacement while the unit is still connected to the coaxial cable. Remove the cover screws from the antenna.
Why is my power antenna not going up and down?
If your power radio antenna won’t go up and down anymore, the problem is either a burned-out motor or the geared cable inside the mast. Both are easy DIY fixes. You can do the entire repair in about two hours. The parts run about $25 for a new cable/mast, plus the cost of the special wrench.
Why is my transmission not working in my Pontiac Grand Prix?
Once the transmission gets warm, it revs engine and shifts hard through 1st, 2nd and 3rd gears. Once a speed of 45mph+ is reached the car is fine. Solution, replacing solenoid and having the valve checked out at as well. Transmission began slipping then stopped pulling in any gear. Diagnosed as the Transmission Pressure Control Solenoid.
What to do about a failed transmission solenoid?
Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid. Good news! We found 32 RepairPal Certified shops near you.
What to do when your car stereo stops working?
First, your battery went dead, and now your car stereo is dead, and it’s really shaping up to be just one of those days. So you drive the rest of the way to work in silence, and you hope that the next step isn’t going to be buying a brand new car stereo. And it probably isn’t.
What should I do if my radio signal is weak?
In case the radio is at a favorable state with a strong signal, one should move across holding the antenna. It is essential to address whenever any variation of reception marked. Before that, ensure that the antennal size is considerably long. It is here to note that the antenna size plays a crucial role in deciding the rate of receiving a signal.
Where to connect the radio’s ground wire?
There was NO ground wire on the Mitsubishi wiring harness, so when I installed the radio, I connected it to the DASH LIGHT line in the wiring harness. [Cue the Stump-the-Chumps correct answer sound!] I will rewire this to fix it. Can anyone suggest where to connect the radio’s ground wire?
What causes a car radio to stop working?
In that same vein, a car stereo with a non-functioning radio may be tracked down to an antenna problem if other audio sources, like the CD player, work just fine.
Why does my single Wire FM antenna not work?
When you know how the antenna works, you might figure out where the problem might be whenever there is a signal outage. Single-wire FM antennas tend to be poor performance or receptors when receiving radio signals. The height and distance from obstructions will affect the reception of the signals.
In case the radio is at a favorable state with a strong signal, one should move across holding the antenna. It is essential to address whenever any variation of reception marked. Before that, ensure that the antennal size is considerably long. It is here to note that the antenna size plays a crucial role in deciding the rate of receiving a signal.
How can I tell if my car radio is working?
Start with testing the ground wire (black), accessory wire (red) and constant (yellow). If the wiring is good, then the voltmeter should read 12 volts or the voltage equal to your source. If you realize that there are disparities, it will be good to check with your car’s wiring diagram.
What to do if your dash light is not working?
If your dash lights work but won’t dim and your running light won’t work and your license plate lights are out. Then there are 4 relays directly above the glove box. you can’t see them until you drop the panel.
Why are my dash lights not working on my Toyota Matrix?
2006 Toyota Matrix. If your dash lights work but won’t dim and your running light won’t work and your license plate lights are out. Then there are 4 relays directly above the glove box. you can’t see them until you drop the panel. There are three 10mm bolts just in front of the latch.
What to do if your radio doesn’t have a security code?
If your radio doesn’t have a security code, and all the fusible links and fuses check out, you’ll have to do more diagnostic work to figure out what’s going on. Car radio codes are meant to act as a sort of passive anti-theft feature.
What to do if your dash light does not work?
#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.
If your radio doesn’t have a security code, and all the fusible links and fuses check out, you’ll have to do more diagnostic work to figure out what’s going on. Car radio codes are meant to act as a sort of passive anti-theft feature.
How can i dim the lights on my dashboard?
Begin the process by trying the simplest of solutions first. Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch.
What should I do if my radio antenna is not working?
The antenna lead should not be connected to any other jack. If applicable, change the tuner settings of the car stereo between the Local/Distant ( LX/DX) station selector to switch the tuner sensitivity.
How to troubleshoot poor or no AM or FM radio reception?
If you have an amplifier connected, disconnect the amplifier power. If the AM reception now improves, the amplifier is the problem. There is not a fix for this other than lowering the GAIN feature on the amplifier, if applicable. Try resetting the car stereo. There could also be a poor ground connection.
What to do if your Sirius Radio is not working?
SiriusXM radios have been designed to provide you with trouble-free performance without the need for servicing. If your radio does not appear to be functioning properly, please try these helpful troubleshooting tips. Please note, messages displayed on your SiriusXM radio screen may vary slightly from what’s noted below.
What happens when your car radio stops working?
So, you do not need a mechanic anymore when our car radio stops working suddenly. When you get in your car, play the radio, but it does not work, you become frustrated. It might become difficult for you to investigate the main cause behind it. You may spend a lot of time fixing it, but still, it won’t work.
Why is my CD player not working on my Radio?
When you observe that your CD player is working properly, but the radio isn’t working, the problem is with either the tuner or the antenna. When the antenna gets damaged, it means that the radio is not getting proper signals from the stations.
Why does the radio signal not go through to the speakers?
That is why the radio signal does not go through to the speakers. The reverse also might be happening, if your battery is low, the alternator will definitely supply low and fluctuating power which will activate the amplifier’s protection mode.
How can I tell if my car radio is bad?
The best way to identify if the wiring has problems is using a voltage meter. Start with testing the ground wire (black), accessory wire (red) and constant (yellow). If the wiring is good, then the voltmeter should read 12 volts or the voltage equal to your source.
When you observe that your CD player is working properly, but the radio isn’t working, the problem is with either the tuner or the antenna. When the antenna gets damaged, it means that the radio is not getting proper signals from the stations.
Why do I lose one radio station in a multiplex?
If all other stations are working ok and you have just lost one station. The problem could be due to a number of reasons, the station may have stopped broadcasting or have moved multiplexes rather than a radio fault. All of the stations in one multiplex should be behaving the same way.
Is it possible to fix a car stereo that quit working after the battery died?
And it probably isn’t. In most cases, fixing a car stereo that quit working after the battery died is a lot simpler than that. Of course, it can also be a lot more complicated. There are a few different reasons for a car radio to stop working after the battery has gone completely dead.
The antenna lead should not be connected to any other jack. If applicable, change the tuner settings of the car stereo between the Local/Distant ( LX/DX) station selector to switch the tuner sensitivity.
What causes poor or no AM radio reception?
If applicable, change the tuner settings of the car stereo between the Local/Distant ( LX/DX) station selector to switch the tuner sensitivity. Class D amplifiers may also cause AM reception problems.
And it probably isn’t. In most cases, fixing a car stereo that quit working after the battery died is a lot simpler than that. Of course, it can also be a lot more complicated. There are a few different reasons for a car radio to stop working after the battery has gone completely dead.
What to do if your CB radio has no power?
CB Radio Has No Power. No lights come on the radio. There is also no sound. You cannot transmit or receive. Check Power Cord Connections. Make sure the power cord connections are attached correctly. If your radio has a power plug, make sure it is seated well. Check Fuse. Make sure the CB radio’s fuse is not blown and that it is seated correctly.
What to do if your radio wont turn on?
Take some small gauge wire directly to the battery terminals, and connect to the correct pins on your radio harness/plug (yellow for power, black for ground). See if it even turns on with direct power. Rule out the HU itself first. EDIT, just read the above post.
What does it mean when your car radio doesn’t work?
When It’s Just the Car Radio That Doesn’t Work. If your radio doesn’t work, but you can listen to CDs, MP3 players, and other audio sources, then the problem is either related to the tuner or the antenna.
Why does my clock radio not turn on?
If you have a clock radio and the clock is not running but you are sure power is getting to the system, one of the wires from the clock or clock switch may have come detached from the radio circuit. Radio won’t turn on. Sounds like something rattling inside. One of the tubes came out of its socket. Usually the 50C5.
Why does my radio not work after a battery disconnect?
Radio doesn’t work after battery disconnect – YouTube After changing your car battery the radio will not work. You did it the wrong way. So now you need to reprogram the radio, and you don’t want to break your b… After changing your car battery the radio will not work. You did it the wrong way.
What to do if your car stereo has no sound?
Radios have all sorts of wires going in and out of them. Each wire serves a specific purpose for the car stereo to operate correctly. If you have a car stereo that has no sound than we should start by checking that all the wires are hooked up. A car stereo will always have 3 different power wires going to the deck section.
What can I do about no audio on my Ford Flex?
Their solution is to pull the radio fuse. On my vehicle it’s fuse 29 in the under-dash panel. Well. It worked. Pulled it and immediately jammed it back in and voila. Audio playing. Not sure if this is a long term fix or if something else is at work here but it worked. I honestly didn’t expect it to work.
What happens when a car radio fuse is blown?
In the case of your car radio fuse, it is designed to sacrifice itself to prevent a dangerous amount of current from flowing through your car radio and the associated circuit. If your radio is dead due to a botched jump start or charge, and you’re lucky, then you may find that your car radio fuse is blown.