Why does my Mazda RX8 have no spark?
If you have no spark, you may have a faulty in the immobilizer system, ignition coils, spark plug wires, fouled spark plugs, faulty crank sensor, wiring or computer. but all the coils wouldn’t go bad at same time…right? could only one bad coil cause it not to start? Normally all coils will not fail at the same time.
How can I get my Mazda RX8 to start?
Pull the spark plug wires up on top of the engine and set the spark plug on some good clean metal so gravity will hold it there. You can also connect a small jumper wire to the spark plug threads and to a ground. Just strip a piece of wire and wrap around the outside of the spark plugs threads and attach the other end of the wire to a good ground.
Where are the fuel lines on a Mazda RX8?
There is no fuel lines on the engine. The fuel lines run up the body under the drivers and connect to plastic fuel lines next to the barke master cylinder. The have a red and blue collar on them. Either way, drilling will not harm anything.
Can you put ATF in a Mazda RX8?
Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.
If you have no spark, you may have a faulty in the immobilizer system, ignition coils, spark plug wires, fouled spark plugs, faulty crank sensor, wiring or computer. but all the coils wouldn’t go bad at same time…right? could only one bad coil cause it not to start? Normally all coils will not fail at the same time.
What are the spark plugs for a Mazda RX-8?
Introduction/facts/information. Spark Plug Facts and Information. The spark plugs in your RX-8 are for one, special spark plugs designed specifically for the RX-8. Secondly, there are 4 spark plugs of two different types on an RX-8 engine.
Pull the spark plug wires up on top of the engine and set the spark plug on some good clean metal so gravity will hold it there. You can also connect a small jumper wire to the spark plug threads and to a ground. Just strip a piece of wire and wrap around the outside of the spark plugs threads and attach the other end of the wire to a good ground.
Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.