Why does my Mazda Protege crank but not start?
It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days. Mine was clogged when I was on vacation and mine would crank but would not start.
Why does my Mazda Protege make no noise?
Does it start when you try jumping it. It can also be a bad starter although this will normally have a clicking noise or no noise instead of a cranking noise. It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days.
How to fix a Mazda that stalls at stop?
Remove the air hose from the throttle body. Disconnect the throttle body connector. Remove the throttle body from the intake manifold, with the water hose connected. Clean the throttle body on the air hose side using a soft, clean shop cloth, sprayed with engine cleaner (Mazda recommends their P/N 000-77-A86).
Why are there spark plugs in my Mazda 3?
Took out the spark plugs, then rotated the crankshaft pulley and I could see the camshaft rotate, so that meant to me the timing chain is still in one piece and at least partially functional. Next put a screwdriver into spark plug hole #1 and set the crankshaft pulley to its timing mark.
Why does my car not start when I crank the engine?
The crankshaft position (CKP) sensor monitors the position or rotational speed of the crankshaft. If the crankshaft position sensor has failed completely, and isn’t sending a signal to the (ECU) at all, then the computer won’t send any fuel to the injectors. This will leave you unable to start the car.
It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days. Mine was clogged when I was on vacation and mine would crank but would not start.
Does it start when you try jumping it. It can also be a bad starter although this will normally have a clicking noise or no noise instead of a cranking noise. It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days.
Took out the spark plugs, then rotated the crankshaft pulley and I could see the camshaft rotate, so that meant to me the timing chain is still in one piece and at least partially functional. Next put a screwdriver into spark plug hole #1 and set the crankshaft pulley to its timing mark.
What to do when your car wont start?
Next put a screwdriver into spark plug hole #1 and set the crankshaft pulley to its timing mark. The screwdriver was at its highest point so I figured the timing is correct.
Why does my Mazda B4000 crank but not start?
If the engine cranks but does not start, it may be caused by a tripped inertia switch. Switch the key to “ON” and the fuel pump should be heard running for a second or two. Listen at the gas filler if necessary. The inertia switch is located on the firewall and can be tripped when the parking brake is set too hard and then released.
What to do if your Mazda3 won’t start?
One way to do this is to start your car and let the engine run for a while to recharge the battery. One thing to know: if the battery is over 4-5 years old, it may be completely dead, so it will not recharge and the car will not restart after you turn it off. In this case, you may need a new battery.
How much does a Mazda B3000 engine cost?
The average cost for a Mazda B3000 No Start Diagnosis is between $88 -$111. Learn More Engine will turn over, but won’t start. No gas getting to the injectors.
What kind of engine does a Mazda 3i have?
I have a 2005 Mazda 3i 2.0L 5 speed manual. I bought it back in April with 92,000 miles and it now has 110,000 miles. It has a catback straight pipe exhaust and the previous owner said the engine was swapped, due to a timing chain failure on the previous one.
What kind of engine does a 2002 protege es Mt have?
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
What does the PCM do on a Mazda?
by Ashley Hay. The powertrain control module (PCM), or engine control unit (ECU), is a circuit board computer that stores information pertaining to different areas of your Mazda’s engine. If your Mazda’s check engine light or another malfunction indicator light illuminates, it is because of a signal the PCM received.
Can you reconnect the negative terminal clam on a Mazda?
Reconnect the “Negative” terminal clam on your Mazda’s battery. Based in Columbus, Ga., Ashley Hay has been covering animal health and wellness since 2004, and arts and entertainment since 2008. She holds a Bachelors of Arts in psychology from the University of Central Florida.
How much does a Mazda Protege alternator cost?
This is a how-to video on a 1999-2000 Mazda Protege 1.8L Sedan. It is very easy to install and replace your alternator and belts. Total for parts was $200 from my local auto parts store. at the dealer this would be 500-600. I hope this helps. Please Rate Comment and Subscribe! Loading…
Why does my Mazda 3 not want to start?
You’re getting oil on your spark plug; replace the valve cover gasket, it isn’t very hard, basic tools are needed, and a valve cover gasket kit from a dealership and some gasket maker silicon. It could just be a severe enough leak going through #4 to not want to start.
You’re getting oil on your spark plug; replace the valve cover gasket, it isn’t very hard, basic tools are needed, and a valve cover gasket kit from a dealership and some gasket maker silicon. It could just be a severe enough leak going through #4 to not want to start.
I have a 2005 Mazda 3i 2.0L 5 speed manual. I bought it back in April with 92,000 miles and it now has 110,000 miles. It has a catback straight pipe exhaust and the previous owner said the engine was swapped, due to a timing chain failure on the previous one.
What kind of mileage does a Mazda Protege get?
The Mazda Protege is a sedan. It gets EPA-estimated 28 MPG combined. NEW Take our quiz & meet the car you’ll love. No listings at this time. Get the latest resale value. No listings at this time. Get the latest resale value. No listings at this time. Get the latest resale value. No listings at this time. Get the latest resale value.
Why does my Harley Davidson crank but not start?
There have been a few reports of a P1009 code – incorrect password also. It appears the turn signal and stalls or cranks but will not start. Try removing the ecm and security fuses, wait ten minutes and reinstall the fuses. This “reboots” the turn signal module and the motorcycle will then start from that point on.
What to do if your engine cranks but won’t start?
If so then that is where your problem is. 2004 ford e450 v10 class c motorhome…. cranks but won’t start…we have 1. Changed the crankshaft sensor 2. changed the PCM 3. Camshaft sensor 4. Replaced the fuel Pump 5. Replaced the computer (again) 6. changed the ignition switch 6. checked the Mass air flow sensor.
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
What kind of car wont start with no spark?
The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors. Don’t know about the Pro but some engines won’t enable the spark/fuel pump if there’s no oil pressure detected.
How to troubleshoot a Honda 2.2L no start?
Go to: No Start 2: Checking Fuel. CASE 2: Spark was NOT present in all of the cylinders. The next step is to make sure that you do have fuel pressure with a fuel pressure gauge just to make sure the fuel pump is not a secondary issue. Now, with no spark in any of the engine cylinders, this what I would suggest:
Why does my GM 3.1L engine not start?
If fuel pressure is NOT at specification, then the PASS-Key/Passlock system is not the cause of the no start condition. Confirm that there’s spark in all 6 spark plug wires because the anti-theft system will not disable the ignition system. If spark is present at all 6 cylinders, the next step is to see if the engine starts with starter fluid.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
One way to do this is to start your car and let the engine run for a while to recharge the battery. One thing to know: if the battery is over 4-5 years old, it may be completely dead, so it will not recharge and the car will not restart after you turn it off. In this case, you may need a new battery.
Why does my car not start if the battery is OK?
If the battery is OK, but the starter still won’t start, there could be a number of possible reasons. Here are a few: The ignition switch could be faulty – this is a common problem.
What kind of engine does a Mazda Protege have?
The MazdaSpeed Protege was only sold in the North American market back in 2003 and produced 170 hp (compared to the standard car’s 140 hp) thanks to a T25 Callaway-Garrett turbocharger with an intercooler. Like later MazdaSpeed models, the Protege only came with a manual.
Is the Mazdaspeed still a good looking car?
Mazda still offers good looking cars with manual transmissions, all of which drive very nicely. But we’ve been begging the company to bring back sportier MazdaSpeed models. Like AMG is to Mercedes, MazdaSpeed was the company’s in-house tuner. It’s been silent for years now, which is probably why old MazdaSpeed models are now very affordable.
What is the wiring diagram for a Mazda Protege?
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 1999-2002 Mazda Protege . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle.
What kind of resistor does a Mazda Protege need?
NOTE #1: THIS IS A 1-WIRE DOOR LOCKING SYSTEM, TO LOCK REQUIRES A (-)NEGATIVE THRU A 1500 OHM RESISTOR. TO UNLOCK REQUIRES A STRIGHT (-) NEGATIVE TO THE SAME WIRE.
Why does my Mazda 2 engine not start?
It really can get that one last start out of it. There are a lot of issues that can cause your 2 to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code.
What kind of spark does a Mazda 3 have?
I check the spark by taking out all the spark plugs, then holding one after the other against the metal block and checking for spark while someone turned the ignition. All 4 plugs showed spark, and they looked strong with a bluish spark color.