Why does my Mazda B2600 engine not start?
RAN GREAT, DROVE IT 45 MINUTES, TURNED IT OFF WILL NOT START AGAIN.I HAVE NO SOLUTION AND AM VERY FRUSTRATED, PLEASE PLEASE HELP. Was running fine. Quit 15 miles from home sort of. Still would idle and could just press on the throttle for high idle but would cut out at 1500 RPM.
Why did my 1990 Mazda B2200 stop running?
I REPLACED THE FUEL PUMP AN FILTER ON MY 1990 B2200 MAZDA TRUCK AN IT RAN GREAT FOR THREE WEEKS. I WAS ON MY WAY HOME FROM WORK AND IT JUST QUIT RUNNING. I WAS TOLD IT HAD A FUEL RELY FROM THE DEALERSHIP PARTS DEPARTMENT BUT THEY SAID IT WAS IN THE FUSE BOX ON THE DRIVERSIDE FRONT FENDER.
Why does my 94 Mazda B4000 not start?
We have a 94 Mazda B4000 that has this intermittent starting problem. The dealer charged us $700 to look for the cause, and told us there is nothing wrong. Avoid dealerships at all cost. We started knocking the fuse box with our knuckles while the other person turned the ignition and it started.
What to do if your car cranks but won’t start?
Share it! If the engine cranks but won’t start, the fault may be internal to the distributor. Diagnosis will show no spark and trouble codes for the crankshaft position sensor (CKP) or the camshaft position sensor (CMP). Our technicians recommend replacement of the complete distributor assembly if these conditions occur. Ready to sell?
RAN GREAT, DROVE IT 45 MINUTES, TURNED IT OFF WILL NOT START AGAIN.I HAVE NO SOLUTION AND AM VERY FRUSTRATED, PLEASE PLEASE HELP. Was running fine. Quit 15 miles from home sort of. Still would idle and could just press on the throttle for high idle but would cut out at 1500 RPM.
What happens if there is no spark in the ignition coil?
Hence, without this high voltage, there is no spark and, consequently, internal combustion cannot take place within the engine. Simply put, the bottom line is without spark the engine doesn’t run.
How can I tell if my ignition coil is on fire?
Have someone crank the engine and observe the center electrode of the plug — if there’s sufficient voltage reaching the plug, you should see a bright blue spark jump across the gap of the electrode every time that cylinder fires. If you see no spark, the coil is a good thing to suspect next.
What causes a car to not start with no gas?
Problem may be at wiring connector on top of fuel tank (hard to reach!). No gas in fuel tank (Check the fuel gauge, and keep in mind the gauge may not be reading accurately). Bad gas (Contaminated with water or too much alcohol or diesel fuel). If you just filled up with gas and now your car won’t start, suspect bad gas.
Hence, without this high voltage, there is no spark and, consequently, internal combustion cannot take place within the engine. Simply put, the bottom line is without spark the engine doesn’t run.
What to do if your ignition coil is on fire?
Replace the coil with a good quality new one, make sure you attach and tighten the leads correctly, plug in the top cable that goes to the distributor, turn the key and you should be good to go!
What should the resistance of an ignition coil be?
Switch the meter’s resistance range to the 20K-ohm setting and attach the negative (black) meter lead to the center terminal of the coil. The reading here should be 11.00 or better, with 13.49 being about normal. If your coil reads under 11.00, then chances are pretty good that this is the reason you’re not getting any spark or a very weak one.
Can a bad ignition pickup cause an engine to stall?
One of the first symptoms of a bad ignition pickup is an engine that stalls and eventually will not restart. Consequently, An old or failing ignition pickup may cut out signal intermittently, which may cause the engine to stall. The engine may suddenly just shut off, almost as if the key had been turned off.