Why does my Harley Davidson have a vibration problem?
I have a vibration problem that occurs when I release the throttle to slow down or come to a stop. At a certain rpm it vibrates so bad it sounds as if the fairing and tourpak are going to fall off. The vibration has already ruined the front motor mount which I replaced.
Why does my C230 vibration at stop when gear engaged?
My C230 has been vibrating….Symptoms: When your idle in drive is shakes pretty rough but when you put it in reverse it doesn’t shake. I had the plugs, cables and coils changed with no luck. Thanks everyone! After reviewing this forum it sounds like the motor mounts.
What kind of vibration does a 1993 Mercedes Benz have?
Now no vibribration, my car is 1993 diesel and vibrate like a 2011 gas car. It looks like the three mounts (left, right, and tranny) are about $170 total on autohausaz.com. Did you find them anywhere cheaper?
Is there a limit to vibration on a hard drive?
The limit is an RMS number, so therefore we can conclude that if all hard drives had to worry about was their own excitation, vibration-induced degradation is not a problem. If we rigidly couple the HDD to anything massive, vibration is dramatically reduced.
I have a vibration problem that occurs when I release the throttle to slow down or come to a stop. At a certain rpm it vibrates so bad it sounds as if the fairing and tourpak are going to fall off. The vibration has already ruined the front motor mount which I replaced.
When does vibration start in a Mercedes Benz?
Mercedes-Benz the engine mounts start to loose fluid around the 100k mile mark. Once a crack develops on the motor mount, they loose all the fluid over time and the vibrations get worse. Mercedes cars have three mounts.
Why does my car vibrate when I come to a stop?
When it is not the brake pads, and calipers squeeze on the deformed brake pads making the car come to a stop. The grip is uneven, and that is why your car will vibrate when it comes to a halt. You should take your car to your auto service shop immediately and have your braking system checked. Vehicles are made up of so many rotating parts.
What kind of vibration does a 2000 Electra Glide have?
I had the same problem and here’s the story. My 2000 Electra Glide has a little over 50K miles on it. At about the 40K mile mark I replaced the front motor mount. After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts.
When does vibration go away on a V-twin?
When everything was loose, I started the bike and let it idle for about half a minute and then ran it up to about 4500 RPM’s for another 15 seconds or so and then let it idle for about another minute. Then revved it up and down and vibration gone!
What kind of vibration does an Indy bike have?
After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts. Took it to several shops, both HD and indy guy and none of them could figure it out. They did get it so the vibration only bad between 1300 to 2000 RPM’s, but still unbearable.
I had the same problem and here’s the story. My 2000 Electra Glide has a little over 50K miles on it. At about the 40K mile mark I replaced the front motor mount. After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts.
When everything was loose, I started the bike and let it idle for about half a minute and then ran it up to about 4500 RPM’s for another 15 seconds or so and then let it idle for about another minute. Then revved it up and down and vibration gone!
After changing it, the bike developed a terrible vibration between 1500 to 2500 RPM’s. Shook so bad it started breaking faring mounts. Took it to several shops, both HD and indy guy and none of them could figure it out. They did get it so the vibration only bad between 1300 to 2000 RPM’s, but still unbearable.
What causes a Harley Davidson motorcycle to wobble?
There aren’t any Harley Davidson model years that are known for a “death wobble” condition. Actually, “death wobble” is usually associated with Jeep Wrangler JK models with bad ball joints. Any motorcycle can have a “wobble” or an unstable feel due to a number of issues. Neck, out of adjustment / neck bearings
Why does my Harley Davidson have a lot of vibration?
A FEW do tend to un-align and go OUT and that causes a LOT of vibration, could break the oil-pump gerotors. as the crank wobbles inside the tight clearances of the oil pump… IF it feels like totally in the engine, It should be checked.
There aren’t any Harley Davidson model years that are known for a “death wobble” condition. Actually, “death wobble” is usually associated with Jeep Wrangler JK models with bad ball joints. Any motorcycle can have a “wobble” or an unstable feel due to a number of issues. Neck, out of adjustment / neck bearings
How do you remove vibration from a V-twin engine?
Removed the rider foot rests and lightly loosened the two bracket bolts that hold the swingarm isolators on each side. Lifted the tank and removed one bolt from the top heim mount and removed one bolt from the lower heim mount at the front of the engine.
Removed the rider foot rests and lightly loosened the two bracket bolts that hold the swingarm isolators on each side. Lifted the tank and removed one bolt from the top heim mount and removed one bolt from the lower heim mount at the front of the engine.
Why does my rear differential make a whirling noise?
Rumbling and whirring noises at speed over 20 mph, moreover, can be the result of worn carrier bearings. For vehicles with C-clip axles, the rear differential noise may change at different turns.
What are the symptoms of a bad throttle position sensor?
A faulty throttle position sensor sends incorrect information to the ECM resulting in various issues in the engine, its performance, and fuel economy. Below are common symptoms of a faulty TPS. In most of the cases, all of these symptoms will show together making it easier to detect the faulty component. 1) Car Jerks
How is the throttle connected to the accelerator?
In the old days, there used to be a cable that was connected from the throttle to the accelerator. But now in the technological age, the car’s computer controls when the throttle opens and closes by the feedback it gets about the acceleration of the vehicle.
Why does my car vibrate or make noises?
Chassis components, specially around the rear of the vehicle, can be a source of noise and vibration when worn or loose. Sometimes, they can be heard during acceleration at relatively low speeds, usually above 20 mph. 4. Constant Velocity Joints
Why do universal joints cause noise and vibration?
Universal joints can be a source of noise and vibration when they develop problems or wear out. This problem affects large rear-wheel drive, 4WD and AWD vehicles using a drive shaft assembly.