Why does my Audi A4 make a clunking noise when braking?
If your bolts are the correct size and are torqued to spec, move on to Step 2. They might be grabbing too aggressively. Some owners have reported that their clunking problem comes from brake pads that grab the rotors too aggressively when the car is in reverse, causing them to move and generate a clunking noise.
What to do if your Audi A4 has a transmission problem?
The following common transmission problems are usually accompanied by the appearance of the “ Check Engine ” light on the dashboard of your Audi A4 or A6. Do not ignore this warning. Instead, take your car to a shop such as Desert Oasis European Auto Service and Repair as soon as possible.
What was the problem with my Audi A5?
Problem professionally and immediately corrected by The Auto Gallery Audi dealer, Woodland Hills, CA. Car had a driveline vibration on the highway. Audi replaced the propeller shaft. All is well again. Clutch replaced due to bad throw-out bearing. Leaking seals replaced in differential.
Is there a problem with the torque converter on an Audi A4?
If you are experiencing trouble with your torque converter clutch, you may feel a slight jolt when you’re driving as your Audi switches gears. Unless you catch the problem right away (generally before the warning light) you will need to completely replace the clutch.
Why does my car make a noise when I change the brake pads?
When the brake pads are worn down and need replacing, this metal tab starts to drag along the rotor, warning the driver of the potential problem. Don’t ignore the noise too long; the brake pads are thin and need servicing very soon, for safety and to protect the other parts of the braking system.
Why does my car squeak when I take my foot off the brake?
The noise when taking your foot off the brake may be normal because all parts are new, the squeak noise is most likely caused by the aftermarket brake pads, ( I assume all parts are aftermarket ). Depending on the quality of the pads and the type of brake pad material will determine how quiet they will be.
What to do when your car makes a noise when you brake?
There are several ways to fix this noise. One is to replace the rear drums. A second, less-drastic way is to remove the drums, install them on a lathe, and sand the crap out of the mating surface with coarse sandpaper. The third way I found by trial and error (and pure frustration) is a quick fix using the emergency brake.