Why does my 350 Chevy truck not start?
350 chevy truck cranks but won’t start – Maintenance/Repairs – Car Talk Community Truck ran fine with no indication of problem. When outside temp. dropped in teens one morning it wouldn't start.
Why does my Vortec truck won’t start?
Also I haven’t fully checked the Spark, but the Truck run’s fine when you spray Starting fluid into the Throttle body. Any suggestions on why the truck isn’t accepting the fuel, it cranks fine, just wont run without starting fluid. these trucks have to have between 55-65psi of fuel to run. Get a pressure tester and check it.
What to do about no start 5.7 Vortec?
No start 5.7 Vortec – YouTube ECM B fuse blowing 98 Chevy GMC problem found. No start 5.7 Vortec If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Can a 1999 Chevy c1500 / k1500 start?
Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so. 205 people found this helpful.
350 chevy truck cranks but won’t start – Maintenance/Repairs – Car Talk Community Truck ran fine with no indication of problem. When outside temp. dropped in teens one morning it wouldn’t start.
What to do if your Vortec won’t start?
96 Chevy C1500 5.7L Vortec Truck won’t start, Replaced Fuel Pump, Filter & Has Spark. Hey everyone, I have a 1996 Chevy C1500 with a 5.7L Vortec, I got the truck recently and was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter, also the pump turns on and there is fuel up at the rail, I pushed the pin and it shot right out.
Why does my Chevy C / K 1500 not start?
FYI – If the pass lock isn’t working properly, the computer will not keep the fuel pump on when the key is turned to start and released. 72 people found this helpful. Note: If the battery dies or is disconnected, or the computer is disconnected, this procedure may have to be repeated.
What to do if your Chevy truck won’t crank?
Found no spark. Replace HEI distributor and no start. Have replaced spark plugs, had starter and battery tested. All are good. Edelbrock 600cfm carb is 6 months old. Truck was completely restored 20000 miles ago so mechanically it’s a new truck. I have no idea why it won’t crank. Buying Guides Deals Car Reviews Repair Shops Community Cars A-Z
Why does my GM 4.3L engine not start?
No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.
Why does my car not start when I start it?
There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start…it’s because one of these components is missing from the mix.
Found no spark. Replace HEI distributor and no start. Have replaced spark plugs, had starter and battery tested. All are good. Edelbrock 600cfm carb is 6 months old. Truck was completely restored 20000 miles ago so mechanically it’s a new truck. I have no idea why it won’t crank. Buying Guides Deals Car Reviews Repair Shops Community Cars A-Z
How to troubleshoot a no start GM 4.3L pick up?
Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.
Why does my Chevy Truck start too slow?
If it’s extremely slow or fast, that would be something to be concerned about. Too slow is either a starter motor problem or a electrical supply issue. Too fast can indicate a broken timing chain for example. Not sure why you changed the starter motor unless it was turning the engine over too slowly.
Why does my Chevy 350 backfire under load?
When high performance turbo engines are under load they use an excessive amount of fuel which then is transferred into the exhaust system once the throttle is let up on and the engine is de-accelerating. This is a normal event and there is no problem with this condition.
What to do if your Camaro 350 wont start?
Im stuck. Optional Information: Pre- 1983 Chevrolet Camaro 350Already Tried: checked firing order, gets spark, gas in the card. Turned the Dist 180 tried multiple positions with dist. The distributor will go in more than two positions,the oil pump drive rod will rotate as the distributor are repositioned.Is it trying to start ?
What to do if your Chevy 350 turns over?
New rebuilt Chevy 350 turns over but it will not start. New Eldebroke Carburator in place carb is spitting out. I have turned the carb 180 still no fire. I have checked for spark and there is spark. I asked about this earlier here and was advised to move the dist over 1 tooth, but it only goes in 2 spots 180 apart. Im stuck.
What kind of ignition does a 1970 Chevy 350 have?
1970 350 chevy, 4 barrel carb, all stock engine except replaced breaker points with Ignitor solid state breakerless ignition. I have recently changed dist cap/rotor, cleaned spark plugs, cleaned insid … read more I resently rebuilt a 350 chevy, and has been runing for about 3 months now. but it doesn’t start any more, it turns over but wont fire.
What are common reasons my Lexus GS350 won’t start?
What are common reasons my Lexus GS350 won’t start? While there are a variety of reasons your Lexus GS350 won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
Im stuck. Optional Information: Pre- 1983 Chevrolet Camaro 350Already Tried: checked firing order, gets spark, gas in the card. Turned the Dist 180 tried multiple positions with dist. The distributor will go in more than two positions,the oil pump drive rod will rotate as the distributor are repositioned.Is it trying to start ?
What to do if your Ford F350 won’t start?
It is highly likely that if your F350 won’t start that there will be codes. These codes will tell you what the computer is saying is wrong with your engine. By looking them up on this site, or just Googling them in general will lead you to a detailed diagnosis of that code.
What causes a Chevy C / K to stop running?
A leaky fuel pump will drain the line up to the carb, but about 15 seconds of cranking will fill the line again. 2. A sticking mechanical choke or a bad electric choke. Try; when you return to your truck from the Quicky Mart, put the accelerator slowly all the way to the floor, let your foot up slowly and then crank the engine.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
How to troubleshoot an overheating Chevrolet 350 engine?
Twist off the radiator cap after allowing the engine to cool, then look into the radiator to observe the level of antifreeze. Pour antifreeze into the radiator until full if necessary. With the radiator cap off, start the engine and look through the radiator opening while the engine warms.
A leaky fuel pump will drain the line up to the carb, but about 15 seconds of cranking will fill the line again. 2. A sticking mechanical choke or a bad electric choke. Try; when you return to your truck from the Quicky Mart, put the accelerator slowly all the way to the floor, let your foot up slowly and then crank the engine.
What causes a car to not start with no spark?
Without spark, the engine will Crank but Not Start. The ignition system of the GM vehicles covered by this article use a distributor type system. In my experience, the most common component failures, of the ignition system that cause a No Start No Spark Condition are: Distributor cap. Crank sensor.