Why does Hitachi AC blink red?
The red light will light up if it is time to clean your filter. The indicator on your AC remote will turn off when your AC filter gets dirty again, if you press the filter button after cleaning. There is no need to press the reset button.
How do you reset the red light on a Hitachi AC?
Put your AC on Standby mode and press the filter key. Leave it until the AC shuts automatically. Once it shuts, press the filter key again to switch off the light. A red light indicates that it’s time to clean your filter.
What should I do if my Hitachi AC is not cooling?
Clogged air filter If the Hitachi AC does not cool, the air filter might be clogged. In such case, air cannot flow through properly which greatly reduces the cooling capacity of the AC. Either clean the air filter or replace it as needed.
Why does my Toyota Sequoia have a blinking AC Light?
By the way my sequoia is a 2001 with 141,000 miles on it and I have never turned the AC off, even in the winter I run the compressor, I have a theory that it keeps everything lubricated instead of drying out seals during the winter. I have never had any AC work done and it blows cold.
Why does my AC Light keep blinking green?
Yesterday out of no where my AC light started to blink and the AC went out, one time i was able to get it to come back on but it only stayed on for a few minutes then went out again. After searching the forums I kept coming across the same thing, the flashing green light of death means your compressor grenaded!
What to do if your AC light flashes in your Toyota?
Hotwire the AC clutch and start the engine. If the Toyota AC light flashing condition disappears, replace the AC clutch relay. If the AC light flashes, make sure the magnetic pickup inside the compressor is still in place. Sometimes they can fall out. If you still have the Toyota AC light flashing condition, replace the sensor
Why does the blinking light come on on my Toyota Tundra?
I could turn the compressor by hand, it was smooth and had slight resistance that keeps it from free spinning. I observed the clutch engaging with the truck running and switch being turned on. It turned slow, much slower than the pulley. The light would start blinking after a few seconds.