Why did the Lights Go Dim at the Indy 500?
The dennis kirk regulator should have worked ok …..sounds like you have a defective one. All the regulator is guys is a zenor diode which allows electricity to pass through it when the voltage exceeds a certain threshold. It then bleeds the extra voltage to chassis ground thereby limiting the maximum voltage.
What are the head lights on a Polaris Indy storm?
It will crank over battery is I have a 2005 Polaris 500 ATP. It will crank over battery is good the instruments lights will not turn on and the head lights will do from very dim to bright but they flicker. You can jump the battery… read more Jeff Policky
How many ohms are in the Indy 500 lights?
The book says .2 to .4 ohms yellow to yellow/red stripe at room temperature. Then run engine at 3000 rpm and check a/c voltage is 15-45 volts at the connector (disconnected). Trouble is if the coil has an intermittant internal short in the windings it may test ok. Okay, I did the car battery test.
What are the specs of a Polaris Indy storm 800?
2014 POLARIS RZR 800 S EPS, CHECK ENGINE LIGHT IS ON, 4X4 LIGHT WILL NOT TURN 4X4 OF I HAVE 12V TO THE FRONT DIFF AND MY WIRES TO SWITCH IS 24OHMS ASFACTORY SPECS … read more Shawn Few AS 135 satisfied customers
The dennis kirk regulator should have worked ok …..sounds like you have a defective one. All the regulator is guys is a zenor diode which allows electricity to pass through it when the voltage exceeds a certain threshold. It then bleeds the extra voltage to chassis ground thereby limiting the maximum voltage.
It will crank over battery is I have a 2005 Polaris 500 ATP. It will crank over battery is good the instruments lights will not turn on and the head lights will do from very dim to bright but they flicker. You can jump the battery… read more Jeff Policky
Are there any Polaris Indy 500 parts left?
Only 1 left in stock – order soon. . Only 2 left in stock – order soon. . Only 3 left in stock – order soon. . Only 9 left in stock – order soon.
Where are the holes in the 1989 Polaris Indy 500?
1989 Polaris Indy 500! Does anyone have exact measurements of where i would drill the new holes for the suspension? Are they level horizontally with the old holes or shifted at all?