Why am I not getting any power to my aftermarket radio?
Possible Solution: First off, check your wiring. If you do not have power, and you know for a fact your wiring is correct, check the fuses under the dash or under the hood (depending on your vehicle). Easiest way to locate the correct fuse is to look in the Owner’s Manual and find the fuse number and box location.
Why is my Jeep Wrangler radio not working?
The radio in my 2012 is acting up too. If I use the remote starter before getting in the radio will work fine but if I shut off the engine and restart it does the in – out volume thing, clicking every time. WF approved Offical Jeep Account. Any fixes for this yet?
Why does my Behringer AMP not power up?
I have an A500 Behringer power amp that will not power up. I replaced the power cord and fuse with known working ones, with no result. Next, I took the fuse I tested in it and plugged it back into a working amp of the same model, which ran fine (so I know the amp isn’t just killing fuses).
Why are the lights on my amp NOT working?
Every once in a long while, the lights on the front of the power amp will light briefly and then die, but 98 percent of the time, nothing. I have opened it up, and here is the power path: As you can see, there is a green/yellow ground.
What should I do if my amp won’t power up?
Do one side at a time. Have a container for all the bits. Avoid bending the power transistors leads once you remove the screws holding the circuit board from the heat sink. Was this answer helpful?
Why is my JK radio not working on my Jeep Wrangler?
My 2008 JK radio quit working. It would go off and on but then would not work at all. I took the radio out and check the wiring harness and it is getting power. Put a new radio in and it won’t power on at all. Checked the fuse box and all is good.
What to do when your radio won’t turn on?
Put a test light across the power leads at the radio. If there is power, and you have a good ground, you either need a new radio or the lead isn’t making good contact t the plug. If not, check for power ar the fuse. If there is power there, the wire is bad between the fuse and the radio.
Why is my amp NOT working with my speakers?
If your amp turns on but no sound comes out of the speakers, your overall setup may be the problem. Not all speakers are compatible with an amp. If your amp is still alive, it will respond when you connect it to speakers and other devices in good condition. Turn up the volume to see if anything changes.
I have an A500 Behringer power amp that will not power up. I replaced the power cord and fuse with known working ones, with no result. Next, I took the fuse I tested in it and plugged it back into a working amp of the same model, which ran fine (so I know the amp isn’t just killing fuses).