Who is the biggest motorcycle manufacturer in the world?

Who is the biggest motorcycle manufacturer in the world?

Honda
Honda is currently the largest motorcycle manufacturer in the world.

What causes a Harley Davidson not to start?

Some other ideas: 1 Problem with security module or key FOB 2 Problem with clutch safety switch, or its wiring (if bike has it) 3 Bad relay (like you said)

How often does a Harley Davidson engine fail?

This metal-to-metal contact promotes engine failures which can be dangerous to you and your bike. This problem can occur anywhere from 15,000 to 75,000 miles depending on the severity. The only way to truly avoid this problem is to completely swap out the chain system for a gear-driven system.

When does a Harley Davidson engine misfire at low speeds?

However, when cruising along about 25-30 mph (in either 2nd or 3rd gear) it is always misfiring and sputtering pretty bad now (had a little hint originally and definitely getting worse now). After coming to a stop, the idle is a bit rough and sometimes the engine acts like it wants to cut out for a few seconds after which it seems to idle OK.

Can a Harley Davidson run at low speeds?

However, since I bought it the engine is not running well at low speeds. It basically runs fine under mild/strong acceleration or at full highway speed and seems to idle normally when the bike is started.

When did my Wife’s Harley start to misfire?

My wife’s 2005 FLHTCUSE2 began to develop problems a few weeks ago. After a short ride, we stopped for her to get gas. On the way home, her Harley started to misfire and run poorly. I lost sight of her so I pulled over. After about 15 mins she showed up and said her bike would not stay running.

What was the problem with my Harley Davidson?

After about 15 mins she showed up and said her bike would not stay running. At each stop, it would stall but would always start after the fact. It died in the driveway. We tried to troubleshoot the problem but have been unsuccessful so far. Checked the fuel pump, getting gas, changed the plugs and checked the wires for leaks, no leaks.

However, since I bought it the engine is not running well at low speeds. It basically runs fine under mild/strong acceleration or at full highway speed and seems to idle normally when the bike is started.

However, when cruising along about 25-30 mph (in either 2nd or 3rd gear) it is always misfiring and sputtering pretty bad now (had a little hint originally and definitely getting worse now). After coming to a stop, the idle is a bit rough and sometimes the engine acts like it wants to cut out for a few seconds after which it seems to idle OK.