Which fuse is for my tail lights?
The tail light fuse may be located in either the fuse panel in the front passenger side of your vehicle or in the main fuse box under the hood. Once you’ve opened either the panel or the main fuse box, locate the tail light fuse. If you’re unsure which one it is, use the owner’s manual for guidance.
How do you check the fuses on a Subaru Outback?
Subaru Outback: Fuses
- Turn the ignition switch to the “LOCK” position and turn off all electrical accessories.
- Remove the cover.
- Determine which fuse may be blown.
- Pull out the fuse with the fuse puller.
- Inspect the fuse.
- If the same fuse blows again, this indicates that its system has a problem.
How do you reset the dash lights on a Subaru?
How to Reset a Subaru Check Engine Light
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
Where is the fuse for parking lights?
There are generally two areas that contain fuses in a car. One is a fuse panel inside the cabin of the vehicle. This is normally in the front passenger side, behind a plastic panel underneath the dash. In certain cars it can be found on the side of the dash with the passenger side door opened all the way.
What would cause my tail lights to not work?
Sometimes failure in the socket might lead to the tail lights not working. The reason why the sockets might get damaged is moisture. Sometimes buildup of any type of moisture might mess up the wiring, and then that would lead to failure. Poor connection of the wiring might also lead to the sockets not working properly.
What kind of fuses does a Subaru Outback use?
Cigar lighter (power outlet) fuses in the Subaru Outback are the fuses #2 “12V SOCKET” and #7 “CIGAR” in the Instrument panel fuse box.
Why do I have brake lights but no tail lights?
One of the main reasons why you might see your brake lights working while your tail lights don’t is because the bulbs installed in the tail light were faulty. You should run some tests to make sure if the bulbs are the main culprit or not and to do that, you will need to remove the tail light cover.
When did the Subaru Outback fuse box come out?
In this article, we consider the second-generation Subaru Outback, produced from 1999 to 2004. Here you will find fuse box diagrams of Subaru Outback 1999, 2000, 2001, 2002, 2003 and 2004, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).
What are the warning lights on a Subaru?
The following are warning lights and indicators found in vehicles built by Subaru. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are nearly 50 of them so be patient!
Where is the fuse box on a Subaru Forester?
The fuse box is located behind the cover to the left of the steering wheel. How to check the fuses? How to replace a blown fuse? Why do car fuses blow?