Where to install alignment tool on LH timing chain?

Install alignment tool EN 46105-1 to the rear of LH camshaft. See Diagrams #1 & #2. You may need to use a spanner on the flat part of the camshafts to get the tool to fit. Note: Do not force or hammer the alignment tool onto the camshaft.

What’s the best way to change a timing chain?

Remove the bolt and washer in the center of the pulley. Put the bolt partially back in the bolt hole and use a harmonic balancer removal tool. The tool should not be a jaw type tool, but instead should apply all of the removal force to the center of the assembly. This protects the rubber ring in the harmonic balancer.

What are the bright links on a timing chain?

Locate marks or “bright” links in your timing chain. These links are brighter than the other links and are used to align your engine. Set your engine to top dead center. To get your engine to top dead center, line the bright links on the timing chain up with the marks on your camshaft and crankshaft gears.

How to remove timing chain from Alloytec engine?

2988 VACC Tech Talk – September 2009 Alloytec Timing ChainTech Talk 13.emove camshaft position sensors and variable R camshaft timing solenoids from engine. 14. Remove timing chain cover. 15. Turn crankshaft clockwise using special tool EN 46111, until the stage one (first) timing marks are aligned. See Diagrams #3 and #4.

Where are the timing marks on Alloytec timing chain?

3. Turn LH intermediate chain sprocket to the position shown in Diagram #4. Diagram #6 Triangular and Circular Timing Marks correspond with Right And Left Diagram #5 Crankshaft at Stage One Timing Mark Do Not Remove Lower Primary Chain Guide or Dismantle Oil Pump VACC Tech Talk – September 20092991 Tech TalkAlloytec Timing Chain

Navigation