Where is the transmission seal on a Honda Civic?

Where is the transmission seal on a Honda Civic?

Also known as the output shaft seal, this component is the most common source of the leak. The axle shaft seal is located between the axle and transmission. Here are the steps to diagnose: Raise the vehicle, and set it down on jack stands. Shine a flashlight through the chassis to where the axle shaft meets the transmission.

Is the 2007 Honda Civic Hybrid under warranty?

We called Honda and they said too bad even though our car was under warranty. We are very disappointed in Honda because they are only thinking about their bottom line (they don’t want to buy new batteries) and not customer satisfaction or safety. I use my 07 civic hybrid as a communter car to and from work.

How do you fix axle seals on Honda Civic?

With the axle back in the transmission, press the axle back into the hub. Re-install the axle nut (torque spec is usually in excess of 120 ft/lb.) and cotter pin. Re-install the outer tie rod into the hub; this will help the hub be oriented in the correct direction to re-install the upper control arm.

Can a Honda Civic Hybrid battery be replaced?

Direct fit replacement for all 2005-2007 Honda Civic hybrid batteries. All backed by our Green Bean Warranty with an optional Lifetime Upgrade option. Installation included in the battery price; see the Free Mobile Installation tab for more information on our service area.

How do you remove seal from Honda Civic?

Pull the axle away from the transmission housing to access the worn seal. With the seal puller, gently pry the seal up and away from the transmission housing, removing it completely from the housing. Avoid scratching or gouging the transmission housing with the tool. Figure 5. Seal puller. Figure 6. Using the seal puller to remove the old seal.

Why are the axle seals leaking on my Honda Civic?

Most axle seals leak because they were not properly seated during installation. Fortunately, the repair is relatively simple. This article applies to the Honda Civic (1990-2000).

Can you get windshield molding for a Honda Civic?

Supreme Trading Genuine Direct-Fit, Front Upper Windshield Trim Molding Replacement for 2012 – to – 2015 Honda Civic 2-Door Coupe. OEM 73150-TS8-A01, 73126-SYY-000, with Free Installation Tools . Only 15 left in stock – order soon. . Only 10 left in stock – order soon. . . Only 16 left in stock – order soon. . Only 4 left in stock – order soon. .

How do you remove axle from Honda Civic?

Tie rod end disassembled. With all of the accessory hub items removed, remove the axle from the transmission. To do this, unbolt the hub from the axle by removing the cotter pin, and using an axle nut tool to remove the axle nut. This will free the axle from the hub side. From here, you have access to the inside of the axle.