Where is the thermostat housing on a radiator?
Locate the thermostat housing at the other end of the top radiator hose from the radiator. You are going to drain the radiator so that the coolant will be just below the level of the thermostat housing.
How do you remove a thermostat from a car?
Remove the thermostat housing by using a socket wrench to undo the bolts holding it onto the engine block. Once the housing is free, remove the old thermostat from the housing and discard it.
How do you attach a new thermostat to an engine block?
Place a bead of gasket seal around the face of the thermostat housing, but be careful not to get any sealant inside the housing. Place the new thermostat on the thermostat housing with the spring facing out. Attach the thermostat housing with the new thermostat to the engine block with bolts.
Locate the thermostat housing at the other end of the top radiator hose from the radiator. You are going to drain the radiator so that the coolant will be just below the level of the thermostat housing.
Place a bead of gasket seal around the face of the thermostat housing, but be careful not to get any sealant inside the housing. Place the new thermostat on the thermostat housing with the spring facing out. Attach the thermostat housing with the new thermostat to the engine block with bolts.
How do you put a new thermostat on a car?
Place the new thermostat on the thermostat housing with the spring facing out. Attach the thermostat housing with the new thermostat to the engine block with bolts. Fill the radiator with coolant until it is full, and place the cap back on the radiator.
Is the Mercury Villager powered by a Nissan engine?
Introduced in 1992, the Mercury Villager was built from a joint venture between the Ford Motor Company and Nissan. Just like its counterpart, the Nissan Quest, the Mercury Villager is powered by a Nissan engine.