Where is the reset button on a Honda SRS light?
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
What does SRS stand for in Honda Civic?
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
How do you reset a Honda Accord SRS light?
Locate the small yellow plug in the fuse panel. This is the SRS power connector. Unplug the power connector from the fuse panel. Stick one end of the paperclip into one of the terminals on the end of the power connector, and the other end of the paperclip into the other terminal. Turn the ignition on but do not start the engine.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.
What does the SRS light on a Honda do?
The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.
What is the SRS system on a Honda Accord?
The SRS, or supplemental restraint system, on your Honda Accord is responsible for deploying the airbag in the event of an accident. If this system is malfunctioning, the airbag may not deploy properly during an accident. However, the system does warn you of a system malfunction.
Why does my Honda SRS light not reset?
The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
What does the SRS light on a Honda Civic mean?
The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
Where is the memory erase signal on a Honda?
Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash. In this step, you will internally make the connection in the plug to “short” it.
Why is my SRS light not working on my Honda Accord?
Tried the battery thing, the MES plug light reset and basically nothing works, Most cheap scanners including the Snapon Solus-Pro won’t read air bag .or abs codes.
The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).
What are the DTC codes for Honda SRS airbags?
Honda SRS Airbag DTC Codes. 1 Honda 1988-2002 All Models Codes: 1-1 & 1-2 open circuited Or high Resistance In Drivers Air Bag Inflator 1-3 short circuited To Another Wire In 2 Honda 2002-2011 All Models Codes: 3 Honda CIVIC, CR-V, ELEMENT & RIDGELINE Codes: 4 Honda ODYSSEY Codes: 5 Honda INSIGHT, PILOT S2000 Codes:
How to turn off SRS light on Honda Civic EX coupe?
Unplug the YELLOW SRS service connector. All you need is a paper clip, bend it in 1/2 & insert it into the YELLOW SRS service connector (not the actual fuse panel). 1- W/ the igniton switch “off”, insert the paper clip ito the connector 2- Turn the ignition switch to the “ON” position. 3- The SRS light will come on for 6sec & then turn off.
Tried the battery thing, the MES plug light reset and basically nothing works, Most cheap scanners including the Snapon Solus-Pro won’t read air bag .or abs codes.
How do you troubleshoot the SRS light on a Honda Civic?
Troubleshoot the SRS by finding the blue 2-pin service check connector underneath your glovebox. Turn off the ignition. Wait ten seconds, then connect the U shaped paperclip to the connector. Turn on the ignition and wait for the SRS light to give you a code.
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
Why is my SRS light not working on my Honda Civic?
I recently had this issue with my 1999 Civic SiR, and it turned out the issue was that the internal contact points of the car horn had corroded. Replacing the car horn, and then resetting the SRS light by disconnecting the battery for about 10 or so minutes fixed things.
Where is the SRS plug on a Honda Accord?
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.