Where is the purge valve located on a 2012?
The evaporative emission (evap) canister purge solenoid valve is located in the evap canister, above the rear of the muffler.
Where is the purge valve on a 2014 Ford Focus?
The 2014 Ford Focus has a canister purge valve located at the rear of the vehicle, near the fuel tank. It is fairly easy to location. You will find it in the evaporation canister, right above the muffler.
Where is the purge valve on a 2015 Ford Fusion?
The 2015 Ford Fusion vapor canister purge valve is located above the rear muffler on the evap canister that is connected to Your fuel tank. This is used to purge excessive pressure out of Your fuel tank so that Your vehicle does not become vapor locked and does not leak fumes.
What is a purge valve and how is it used?
The purge valve, also known as the canister purge valve, is part of your vehicle’s evaporative emission control (EVAP) system. It traps the fuel vapors created in your fuel tank and prevents them from escaping into the air. The valve operates using a solenoid, which can sometimes malfunction and cause it to become stuck open or closed.
How much does it cost to replace a purge valve?
On average, a purge valve replacement can cost anywhere from $125 to $225 if you were to hire a professional mechanic. The parts, depending on the car you drive, can be priced between $65 to 125, while the labor, which takes less than an hour to complete, will be anywhere from $40 to $85.
How does a purge valve work in an EVAP system?
EVAP Purge Valve Operation. A flap in the EVAP purge valve body restricts the motion of fluid and is magnetically attracted by the voltage applied via the valve’s electrical contacts. The flap is attracted to a coil in the evaporative purge system, which closes the valve and blocks the passage of fluids.
How do you replace a purge valve?
Step 1: Go under the rear of your car and locate the purge valve. Step 2: Remove the connecting hose and the screws on the valve. Step 3: Once the screws are out, slide the valve out of the canister and gently try to remove the electrical connector on the valve. Step 4: Install the replacement purge valve.