Where is the jack kept on a Mercedes Vito?
The jack is secured in the trunk with a spring loaded latch. The tool roll kit sits inside the plastic “tub” that secures the spare wheel. You can access your owner’s manual by using MB factory’s service manual which is also accessible online.
How do you take a Mercedes tire off?
So, How Do You Change a Car Tire?
- Pull over to a level spot.
- Locate your vehicle’s spare tire, jack, and tire iron/lug wrench.
- Wedge a tire chock under each good tire.
- Use the lug wrench to loosen the lug nuts.
- Jack up the car just enough so that the flat tire is off of the ground.
- Remove the lug nuts and the flat tire.
Where is the spare tire on a Mercedes gl350?
The spare tire is located in the rear compartment under the floor.
How do you pump up a spare tire?
How to Fill a Spare Tire
- Drive to a gas station that has an air compressor if you do not have one at home.
- Remove the spare tire from the vehicle if it is not currently in use.
- Remove the rubber stem cap on the valve of the spare tire.
- Press the fitting on the end of the air hose onto the tire’s valve.
How to remove the spare tire on a Mercedes-Benz Vito?
What is the procedure to remove the spare tire on the Mercedes-Benz Vito AA3CDI? To remove the spare tire on the Mercedes Benz Vito, first the retaining nut needs to be undone using a wheel nut spanner. Typically there are two nuts beside each other. One needs to be removed only a little while the other needs be undone completely.
What is the correct tyre pressure for a Mercedes Benz Vito?
The chart also lists the Mercedes Benz Vito Wheel Nut Torque Setting. What is the correct tyre pressure for a Mercedes Benz Vito ? What is the correct wheel nut torque setting for a Mercedes Benz Vito ?
Are there any problems with the Mercedes Vito?
Questions about Mercedes-Benz Vito Answered One of the common problems to occur with the Mercedes-Benz Vito is failure to start. This can be attributed to many reasons. It may take a fair amount of troubleshooting to arrive at the exact cause.
Where can I buy spare parts for my Vito van?
All our spare parts are brand new, ready to order through our secure online store and ship to you. Choose from auto parts such as head lights, tail lights & indicator lights, bonnets, grilles, front and rear bumpers, mirrors, window regulators, radiators, control arms and more…
What is the procedure to remove the spare tire on the Mercedes-Benz Vito AA3CDI? To remove the spare tire on the Mercedes Benz Vito, first the retaining nut needs to be undone using a wheel nut spanner. Typically there are two nuts beside each other. One needs to be removed only a little while the other needs be undone completely.
Questions about Mercedes-Benz Vito Answered One of the common problems to occur with the Mercedes-Benz Vito is failure to start. This can be attributed to many reasons. It may take a fair amount of troubleshooting to arrive at the exact cause.
How to calculate tyre pressure on a Vito?
(MAx pressure / MAx load for tyre) x (van weight / 4) = tyre pressure setting. This assumes all 4 wheels carry the same weight. To do it properly, replace (Van weight/4) with (axel weight/2) the tyre pressure guide on a vito / mixto is pretty accurate… “heavy” or “full” load is driver + 8 passengers (adults av 10stone) + a dozen suitcases……
Why does the Mercedes Vito go into limp mode?
Why does the Mercedes Vito van (112 CDI 638 chassis) go into limp mode after climbing over a long hill or while under load? The vacuum transducer and turbo pressure sensor were changed. There are a variety of reasons which can result in the Mercedes Vito engine going into a limp mode.