Where is the injector tube on Detroit Diesel Series 60?
Detroit Diesel has made a machining improvement on the Series 60 cylinder head injector tube bore. This machining improvement removes cast iron material from the head at the crevice area, located just above the injector tube to cylinder head sealing land. See Figure “Crevice Area”
Where is the O-ring on Detroit Diesel Series 60?
Discard O-ring. Detroit Diesel has made a machining improvement on the Series 60 cylinder head injector tube bore. This machining improvement removes cast iron material from the head at the crevice area, located just above the injector tube to cylinder head sealing land.
What is the serial number of the injector seat cutter?
An injector nozzle seat cutter (J–45723) is now available to perform this machining process to engines built before engine serial number 06R656739. This tool includes two replacement bits. Additional bits (J–45723–1, part of tool set J–45723) are also available.
Where is the crevice area on Series 60?
Detroit Diesel has made a machining improvement on the Series 60 cylinder head injector tube bore. This machining improvement removes cast iron material from the head at the crevice area, located just above the injector tube to cylinder head sealing land. See Figure “Crevice Area” Figure 3. Crevice Area
How tall is a DDEC Series 60 fuel injector?
FUEL INJECTOR HEIGHTS Models: 6067TKXX, 606XPKXX, 606XGKXX (1997-98 DDEC IV and later 1997 DDEC III) FUEL INJECTOR HEIGHTS Models: 6067EKXX, 606XBKXX, 606XMKXX, 606XLKXX, 606XHKXX, 606XFKXX (1998 & 1999 DDEC IV)
What’s the maximum number of fuel injectors Detroit Diesel can use?
Detroit Diesel purposely randomized the numbers to keep the cowboys out of it! There is a number that allows for maximum fuel injector metering, I was always under the impression it was 75.