Where is the ignition switch on a Pontiac Sunfire?
Put the key in the ignition. Turn it to the “Run” position, but do not start the Sunfire. Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
How do you disabling Sir on a Pontiac Sunfire?
Disabling the SIR System. 1. Turn the steering wheel so that the vehicle’s wheels are pointing straight ahead. 2. Turn the ignition switch to the OFF position. 3. Remove the key from the ignition switch.
How to install a SunFire ignition lock set?
1999 Pontiac Sunfire Ignition Lock Set Install: 1999 Pontiac Is there directions or a procedure to install a new lockset with keys. Thanks have the same problem? CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
What happens if the ignition switch goes out on a Pontiac?
The ignition switch on a Pontiac car Am is responsible for signaling the starter to turn over, which in turn starts the engine. If your Pontiac car Am’s ignition switch goes out, the starter doesn’t know when to engage and the Pontiac car Am will not start.
How do you install an ignition lock on a Pontiac Sunfire?
1. Turn the steering wheel so that the vehicle’s wheels are pointing straight ahead. 2. Turn the ignition switch to the OFF position. 3. Remove the key from the ignition switch. 4. Remove the left Instrument Panel (IP) end cap.
Disabling the SIR System. 1. Turn the steering wheel so that the vehicle’s wheels are pointing straight ahead. 2. Turn the ignition switch to the OFF position. 3. Remove the key from the ignition switch.
Where is the ignition switch on a GM PassLock?
Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.
What are the three wires in a GM ignition switch?
In GM cars, there is a bundle of three wires which go from the Body Control Module to the Ignition Switch. They are Black (analog return), White (power), and Yellow (analog data).
Put the key in the ignition. Turn it to the “Run” position, but do not start the Sunfire. Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
The ignition switch on a Pontiac car Am is responsible for signaling the starter to turn over, which in turn starts the engine. If your Pontiac car Am’s ignition switch goes out, the starter doesn’t know when to engage and the Pontiac car Am will not start.
How to remove the ignition switch in a 1997 Pontiac Bonneville?
Unplug the yellow wiring harness on the steering column with your hands, then unplug the remaining wiring on the column. Remove the ignition switch actuator rod from the ignition switch using the Phillips-head screwdriver. Remove the ignition switch from the car. How to Remove the Ignition Switch in a 1997 Pontiac Bonneville
How to remove the ignition switch in a 1999 Pontiac Trans Am?
Allow the Trans Am to sit for 30 minutes. Lock the steering wheel by pushing it from side to side, then make sure the ignition switch is locked in place as well. Remove the panel below the steering column using the 1/4-inch ratchet and socket.