Menu

Navigation

Where is the engine code on a Kia?

Posted on by Arif Clayton

Where is the engine code on a Kia?

The serial number containing the engine code of your Kia Rio can be found on a sticker attached to the door on the driver’s side. If it’s not there, check under the hood. It would be on the front of the engine. If not, on the driver’s side, at the bottom of the windshield, look behind the wipers.

How do I display check engine codes?

  1. How to read OBD codes: Preparation.
  2. Step 1: Plug the OBD scanner into the OBD port.
  3. Step 2: Turn on the ignition.
  4. Step 3: Enter the Vehicle Identification Number.
  5. Step 4: Find OBD codes in the menu.
  6. Step 5: Interpret the first character of the OBD code.
  7. Step 6: Interpret the second character of the OBD code.

How do I decode a Kia VIN number?

How to Decode a KIA VIN?

  1. K – Country (South Korea)
  2. N – Manufacturer (KIA)
  3. A – Vehicle Type (Passenger Car)
  4. FX4A6 – Description (FWD/4DR/Sedan/KIA Forte)
  5. 4 – Check Digit.
  6. F – Model Year (2015)
  7. 5 – Assembly Plant (Hwasung, South Korea)
  8. 339689 – Production Sequence Number.

How do you reset the check engine light on a Kia?

How Do You Reset Your Check Engine Light?

  1. Turn off your ignition.
  2. Don some safety glasses and gloves.
  3. Locate the negative terminal.
  4. Loosen the negative terminal’s nut with a wrench, then pull the connector from the battery, keeping it to the side for 30 to 60 seconds.
  5. Reconnect the cable and tighten with your wrench.

What engine is Kia?

the VIN number will tell you the engine type, its the 8th digit from the left side 5 = 1.6L Gamma GDI and 6 = 2.0L Nu MPI engine. Or easier still just look on your engine and if its says GDI on the cover its 1.6L and if not 2.0L, also the way the way the vehicle is equipped if its a + model (if your in the US) or !

What is VIN number in Kia?

② The VIN is also on a plate attached to the top of the dashboard. The number on the plate can easily be seen through the windshield from outside. ③ The vehicle certification label attatched on the driver’s side center pillar gives the vehicle identification number (VIN).

How do I check and get engine codes?

Inserting and Reading an OBD Scanner Locate your vehicle’s OBD port. The most common mounting location for an OBD port is under the driver’s side of the dash near the pedals. Plug your OBD scan tool into the connector. The scan tool’s male end will only fit one way onto the vehicle’s connector. Read the codes in the computer. Record the codes that display.

How to ckeck engine light codes?

Chevy Check Engine Light Codes Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. Turn the ignition on. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).

How do you reset the Check Engine light on a Kia Sorento?

How To Reset Kia Sorento Engine Oil Light in 5 Easy Steps! Turn the engine ON If service is due the display will show “Service required” when the vehicle is turned on While the message is displayed press and hold the DOWN arrow button on steering wheel for more than 1 second The service interval will reset to the default setting